Quadra-Fire 5100-I Manual

Also see for 5100I: Specifications

Contents

Quadra-Fire 5100-I Manual Manual pdf 12 page image

5100-I WOOD INSERTPage 12 January 30, 2004R250-1960 Rev BINSTALLATION IN CANADAMASONRY and HEAT-CIRCULATING(INSTALLATIONS INTO FACTORY-BUILT FIREPLACES ARE PROHIBITED IN CANADA)Whether installed in a masonry or heat-circulating fireplace, this fireplace insert must be installed with a continuous chim-ney liner of 6” (152mm) diameter extending from the fireplace insert to the top of the chimney. The chimney liner mustconform to the Class 3 requirements of CAN/ULC-S635, Standard for Lining Systems for Existing Masonry or Factory-BuiltChimneys and Vents, or CAN/ULC-S640, Standard for Lining Systems for New Masonry Chimneys.• Do not remove bricks or mortar from fireplace to accommodate insert.• The face of the fireplace must be sealed to prevent room air passage into the chimney cavity.• The permanent metal warning label provided must be affixed to the back of the fireplace with screws or nailsto the fireplace, in a location readily visible should the fireplace insert by removed, stating that the fireplace mayhave been altered to accommodate the insert, and must be returned to original condition for use as a conventionalfireplace.USE OF LEVELING BOLTSFigure 12ATwo leveling bolts, 3/8” x 4” are shipped inside the component pack found inside the firebox.NOTE: Not all installations will require the use of the leveling bolts. If the leveling bolts are necessary, you will also needsheetmetal guides placed under the leveling bolts to slide insert into position.1. Remove the bolts from the component pack.2. Locate the weld nuts welded to each side of the insert bottom and insert the bolts.3. Position insert on hearth with rear of insert extending into fireplace opening.4. Extend leveling bolts downward to level insert.SECURING LINER TO CHIMNEY RINGThere are two options to secure the liner to the chim-ney ring: (See Figure 12A).Option One: If there is enough room on the top of theinsert to work, hand bend the two tabs upward 90°.Secure the liner with the supplied hex head bolts 1/4-20-3/4.Option Two: Remove the manifold tubes, fiberboardbaffle and ceramic blanket. From inside the firebox,pull liner down through the chimney ring below theouter skin. There are two pre-drilled holes in the chim-ney ring 180° apart. Secure the liner with the suppliedhex head bolts 1/4-20-3/4.NOTE: Tabs are shipped from factory in a flat position.Bend upwards 90 degrees.Attach liner with 2 tabs2 pre-drilled holes onchimney ring under outer skin(access through firebox)