Page 23September 1, 20085700 ACT Wood StoveR250-7090eBRICk REPLACEMENT INSTRUCTIONSUse Part 832-0550 when ordering individual brickprovide brick dimension or copy this page and markthe brick you need and take it to your authorizeddealer.3 3331111111111111111117442 25 561. After the coals have completely cooled, remove all oldbrick and ash from unit and vacuum out firebox.2. remove new brick set from box and lay out to diagramshown above.3. Lay bottom bricks in unit.4. Install rear bricks on the top of the bottom bricks.Slide top of bricks under clip on back of firebox walland push bottom of brick back.5. Install side bricks. Slide top of brick under clips onside of firebox and push the bottom of the brick untilit is flush with the side of the unit.Nbr brick Size Qty in Set1 9 x 4.5 x 1.25” 182 9 x 3.75 x 1.25” 23 9 x 2.0 x 1.25” 44 7 x 3.25 x 1.25” 25 9 x 4.5 x 1.25” with hole 26 6.5” x 2.0” x 1.25” 17 4.5” x 2.0” x 1.25 1GLASS REPLACEMENTReplace with 5mm ceramic glass only1. ensure that the fire is out and the stove is cool to the touch.2. Protect a table or counter top with padding or towels.3. remove the door with the broken glass by lifting the door up and off of the hinges.4. Lay door face down on a table or counter making sure the handle hangs over the edge so the door lays flat, ona soft surface.5. remove the screws from each glass retainer and remove the glass. (If screws are difficult to remove, soak withpenetrating oil first).6. Center the glass with edges evenly overlapping the opening in the door, (i.e. same space top and bottom, leftand right sides).7. replace the glass retainers. be careful not to cross thread the screws.8. Tighten each retainer just a few turns until each is secured. Check again for centering of glass in door frame.Then continue to tighten each retainer alternately, a few turns at a time, until the glass is secured. DO NOTOVerTIgHTeN.9. replace the door on the appliance.