Page 7September 1, 20085700 ACT Wood StoveR250-7090eFLOOR PROTECTION16" from glass8"USAFuel loading door3-3/16"4-13/16"44-9/16"minimum33-5/8"minimumCANADA203mm (8")203mm(8")203mm(8")457mm (18")1387mm(54-9/16")minimum1083mm (42-5/8")minimum52-13/16 in.33-5/8 in.44-7/8 in.29-5/16 in.3-1/16 in.32-1/16 in.135°optionalcoveragemust extend 2" beyond each side of pipeUSAVENT SPECIFICATIONSSingle Wall: Six inch (6”) (152mm) diameter, minimum 24 MSg black or blued steel connector pipe, with a Listed factory-builtchimney type UL103 HT* suitable for use with solid fuels, or a masonry chimney, and the referenced clearances.Double Wall: Six inch (6”) (152mm) diameter, listed double wall air insulated connector pipe with Listed factory-built UL103 HT* Class“A” chimney, or a masonry chimney (Mobile Home must be equipped with a spark arrestor), and the referenced clearances.*In Canada must comply with CAN/ULC-S269-for the 650° C Factory-built chimneyFLOOR PROTECTION: Floor protector must be non-combustible material, extending beneath heater and to the front/sides/rearas indicated. The floor must be non-combustible or otherwise adequately protected from radiant heat given off by the unit andfrom sparks and falling embers. A layer of thin brick or ceramic tile over a combustible floor is not sufficient. A listed hearth padthat has a “k” value of .84 or lower meets this requirement.In US installations, it is necessary to install a floor protector of 1/2" thick metal clad millboard (“k” value = .84) or equivalent atleast 16" (457mm) in front of glass door and 8" (203mm) to both sides of the fuel loading door. Open the door and measure 8”(203mm) from the side edge of the opening in the face of the stove. See *exception below.See Alternate Materials Worksheet on Page 8 to determine if alternate floor protection materials are acceptable.In Canada, similar floor protection must be provided 18" (457mm) in front and 8" (203mm) from the sides and rear of thestove. See *exception below.*EXCEPTION: Non-combustile floor protection must extend beneath the flue pipe when installed with horizontal ventingand extend 2” (51mm) beyond each side.NOTe: Drawings are for illustration purposes only and are not to scale.USA - RequiredCanada - RecommendedUSA