Quadra-Fire CASTILE-MBK-B Owner's Manual

Also see for CASTILE-CSB-B: Owner's manual installation and operation Owner's manual Owner's manual Owner's manual Owner's manual

Quadra-Fire CASTILE-MBK-B Owner's Manual Manual pdf 21 page image

RNovember 21, 2011 7021-130C Page 21Castile-B FS Pellet Stove1. A 12 volt AC thermostat is required to operate this pelletappliance. You may use the included wall mount thermo-stat or purchase an optional programmable thermostator remote control. It is equipped with an adjustableheat anticipator. The current rating is .05 amps. Theanticipator needs to be adjusted to the lowest settingavailable.2. When mounting a thermostat on a wall, be sure to followyour thermostat installation instructions carefully.NOTE: Thermostat must be mounted level foraccurate readings. The thermostat should bemounted on an inside wall and not in direct linewith the appliance convection air.NOTE: If the thermostat is located too close to theappliance, you may need to set the temperaturesetting slightly higher to maintain the desiredtemperature in your home.3. There is a 4 screw terminal block located on the backlower right corner of the stove directly above the powercord inlet. The center 2 screws are for the thermostatwires.F. Thermostat InstallationShock hazard.• Do NOT remove grounding prong from plug.• Plug directly into properly grounded 3 prong recep-tacle.• Route cord away from appliance.• Do NOT route cord under or in front of appliance.CAUTIONTERMINAL BLOCKCENTER 2 SCREWS FORTHERMOSTAT WIRESPOWER OUTLETFUSEFuseFigure 21.1