Quadra-Fire CASTILE-MBK-B Owner's Manual

Also see for CASTILE-CSB-B: Owner's manual installation and operation Owner's manual Owner's manual Owner's manual Owner's manual

Quadra-Fire CASTILE-MBK-B Owner's Manual Manual pdf 35 page image

RNovember 21, 2011 7021-130C Page 35Castile-B FS Pellet StoveG. Baffle & Brick Set Removal2. Convection Blower Replacementa. Turn down thermostat, let appliance completely cooland then unplug appliance before servicing.b. The convection blower is located at the bottom rearof the appliance and is housed inside a screen box.Remove the 2 screws facing forward in the center ofthe blower chamber at the very back of the appliance.c. If an outside air kit is installed on the appliance, thesescrews attach the intake air channel piece of the outsideair kit to the appliance. Remove the 2 screws and pullbackwards on the channel and it will slide down andaway from the appliance. The air channel, collar andoutside air hose will be removed as one piece.d. There are 2 screws on each side of the housing. Loosenall 4 screws, but do not remove them. Lift the blowerhousing up slightly and slide towards you. Figure35.1.e. Remove the left side panel by loosening 2 screws (do notremove) and pull side panel away. Unplug the 2 blackblower wires by disconnecting the spade connectors.f. To remove blower from the housing, remove 2 screwsin the front of the housing and very carefully bend the2 housing sides out and bend the back of the housingaway from the blower. This allows for room to accessthe back 2 screws and nuts (4 total) that is securing theblower to the housing.g. Remove blower and replace with new blower.e. Re-install in reverse order.F. Blower Replacement (Cont’d)Figure 35.1Loosen (do not remove) 2screws on each side and liftoff blower housingRemove left sidepanel and disconnectblower wiresConvection Blower& Housing1. Follow proper shutdown procedures in Section 10.2. The top baffle has a hook on the bottom left side thatrests on the top lip of the cast brick. There is a tab onthe bottom right side that hooks into the side bracket.Remove the top baffle by first pulling the baffle forwarduntil back edge drops down. Then slide baffle back untilthe front edge clears the shelf that it had been resting on.Figure 35.23 . The top baffle must be removed before you can removethe right and left brick. Remove the right brick by hold-ing top lip of brick and lifting up, then push outside edgeback. Slide brick to the right until it is flush with the firebox.Rotate the inside edge of the brick forward and removebrick. Repeat for left brick. Figure 35.3.Remove Right& Left BrickHook onleft side Tab onright sideVacuumExhaust AreaRight BrickRemovedFigure 35.2Figure 35.3Figure 35.4