Quadra-Fire CASTILE-MBK-B Owner's Manual

Also see for CASTILE-CSB-B: Owner's manual installation and operation Owner's manual Owner's manual Owner's manual Owner's manual

Quadra-Fire CASTILE-MBK-B Owner's Manual Manual pdf 19 page image

November 27, 2017 7021-155F 19CASTILE FREESTANDINGA. Glass Replacement - Door Assembly(Replace with 5mm ceramic glass only)1. Open the face and remove door from the appliance bylifting door off of hinge pin and lay on a flat surface facedown.2. Using a screwdriver, tap the bottom of the rope retainerrod to push it up out of the hole. The top end of the rodwill slide up. Swing the rod toward you from the bottomand remove the rod. Repeat for other side.3. Remove old glass and replace with new glass.4. Slide the retainer rod into the top hole first, and thenline up the bottom crimped end with the hole in thedoor. The crimped end must be parallel with the glassin order to insert it into place. Figure 19.1.5 Service Parts ReplacementFigure 19.1Rope RetainerRodsSlide this endin firstCrimped end atthe bottomCrimped endmust beparallel withthe glassGlass• Glass is 5mm thick high temperature heat-re-sistant ceramic glass.• DO NOT REPLACE with any other material.• Alternate material may shatter and causeinjury.WARNINGB. Igniter Replacement1. Shut down the appliance by turning down the thermostatand let the appliance completely cool down. After theappliance has cooled down, unplug it and remove theash drawer.2. The wire leads to the igniter are connected to the wireharness with 1/4 inch male / female spade connectors.Disconnect the spade connections and remove theigniter from the chamber. Loosen thumb screw andslide igniter out.3. Install new igniter into the chamber and tighten thumbscrew. Re-connect the wires to the 2 leads with thespade connectors.4. Double check that the igniter wires are clear of anymovement, i.e. ash drawer, fire pot cleaning rod,cleaning slide plates, etc.5. Re-install the ash drawer and side panel and re-connectthe power.IgniterIgniter BracketThumb ScrewFigure 19.2Shock Risk.• Do NOT remove grounding prong from plug.• Plug directly into properly grounded 3 prongreceptacle.• Route cord away from appliance.• Do NOT route cord under or in front of appliance.CAUTION