Quadra-Fire CB1200I-C Owner's Manual

Also see for CB1200I-C: Installation manual

Contents

Quadra-Fire CB1200I-C Owner's Manual Manual pdf 12 page image

12June 4, 20197027-805CCB1200 Pellet InsertL. Insert RemovalIn the case that service or inspection is required theappliance may need to be removed from the wall.1. Appliance must be unplugged before removal ofappliance is possible. Unplug the appliance from itspower source.2. Remove insert surround from appliance, to ease theprocess of removal.3. Remove the clip from the exhaust transition from theexhaust outlet in the back of the appliance. This is whatconnects the venting to the appliance. Removal of theclips will allow you to remove the appliance from thewall without damaging or adjusting the venting.4. Slide appliance from the wall and rotate either directionas needed.K. Ignition Cycles1. During each ignition cycle, it is normal to see somesmoke in the firebox. The smoke will stop once thefire starts.2. The convection blower will automatically turn on afteryour appliance has reached the set temperature. Thisblower transfers heat from your appliance into theroom, and will continue to run after the thermostathas stopped calling for heat until the appliance hascooled down.3. Occasionally the appliance may run out of fuel and shutitself down. When this happens, the red call light willbe on (Figure 10.1 on page 10). To restart it, fill thehopper and press the reset button. When you press thereset button the red call light will go out. Release thebutton and the light will come back on. You should seea fire shortly. If not, follow the instructions on page 11,“Starting Your First Fire”.WARNINGFire Risk.• High ask fuels, or lack of maintenance,can cause the fire pot to fill with ashand clinker. If the fire pot fills to the top,immediately shut down the appliance andclean.• Failure to do so could result in smoking,sooting and possible hoper fires.N. Clear SpaceMantel: Avoid placing candles and other heat-sensitiveobjects on mantel or hearth. Heat may damagethese objects.Fire Risk.Keep combustible materials, gasoline andother flammable vapors and liquids clear ofappliance.WARNING• Do NOT store flammable materials in theappliance’s vicinity.• DO NOT USE GASOLINE, LANTERN FUEL,KEROSENE, CHARCOAL LIGHTER FLUID ORSIMILAR LIQUIDS TO START OR “FRESHEN UP” AFIRE IN THIS Appliance.• DO NOT BURN GARBAGE OR FLAMMABLEFLUIDS SUCH AS GASOLINE, NAPHTHA ORENGINE OIL.• DO NOT USE CHEMICALS OR FLUIDS TO STARTTHE FIRE.• Keep all such liquids well away from the appliancewhile it is in use.• Combustible materials may ignite.Fire Risk.Do NOT place combustible objects in front ofthe appliance. High temperatures may igniteclothing, furniture or draperies. Maintain aminimum clearance of 3 feet (914mm) in frontof appliance.WARNINGM. Restarting the ApplianceRestart Process1. When the unit has run out of fuel, add pellet fuel tothe hopper.2. Dump the ashes and clinkers built up in the fire pot bypulling the ash dump removal handle out several times.Make sure clinkers have dropped into the ash pan thenreturn the handle to fully closed position.3. Press the reset button; the appliance will then being itsstartup sequence.Restarting After a Power Failure1. For an electrical disruption the appliance will start onits own without need for priming - providing the controlsystem is asking for heat.NOTICE: Clearances may only be reduced by meansapproved by the regulatory authorityhaving jurisdiction.HOT WHILE IN OPERATION. KEEP CHILDREN,CLOTHING AND FURNITURE AWAY. CONTACT MAYCAUSE SKIN BURNS.CAUTION