Quadra-Fire EXCURSION-I Installation Manual

Also see for EXCURSION-I: Owner's manual

Contents

Quadra-Fire EXCURSION-I Installation Manual Manual pdf 31 page image

31Quadra-Fire • EXCURSION-I, EXCURSION-II, EXCURSION-III Installation Manual • 2538-980 Rev. E • 5/19A. Fuel Conversion• Make sure the appliance is compatible with available gastypes.• Conversions must be made by a qualified servicetechnician using Hearth & Home Technologies specifiedand approved parts.• Reference the following diagrams for gas shut off detailand component access.• Reference Section 9.A to remove fixed glass assembly.7 Gas InformationFigure 7.2 Glass Clip Assembly RemovalBASE REFRACTORYGLASS CLIPASSEMBLIESGLASSCLIP ASSEMBYSCREW ACCESSFigure 7.1 Gas Shut-offFigure 7.3 Component Tray• Glass clip assemblies can be removed for additionalcomponent accessibility.• Use multi-purpose tool to assist with gas shutoff. SeeFigure 7.1. The gas ball valve is in the “OFF” positionfrom manufacturer.WARNING! Glass seal plate must be properly installed.Risk of elevated component temps and carbon monoxideexposure.NOTE: Bottom right glass clip on 25 inch models mustbe removed to gain access to controls.OFF POSITION(TURN KNOB CLOCKWISE)NOTE: Use the Multi-PurposeTool to assist with gas shut-off.MULTI-PURPOSE TOOLGAS SHUT OFFGLASS SEAL PLATEPRESSTAB TORELEASEUNCLIPWIRESCOMPONENTTRAYCOMPONENTTRAY RECEIVERCAUTION: Be sure to reinstall the component heat shieldbefore firing the appliance. Components will overheat.NOTE: The gas ballvalve is in the “OFFposition frommanufacturer.