Quadra-Fire EXPLRMED-PBK Instruction Manual

Contents

Quadra-Fire EXPLRMED-PBK Instruction Manual Manual pdf 18 page image

18 7061-197D November 7, 2014Explorer II Medium Wood StoveCAUTIONTHE STRUCTURAL INTEGRITY OF THE MOBILE HOMEFLOOR, WALL AND CEILING/ROOF MUST BE MAINTAINEDDo NOT cut through:• Floor joist, wall, studs or ceiling trusses.• Any supporting material that would affect the structural integ-rity.Asphyxiation Risk.NEVER INSTALL IN A SLEEPING ROOM.Consumes oxygen in the room.WARNINGYou must use a Quadra-Fire Outside Air Kit PartOAK-ACC for installation in a mobile home.1. An outside air inlet must be provided for combustion.2. Appliance must be secured to the mobile home structureby bolting the legs to the floor.3. Appliance must be grounded with #8 solid coppergrounding wire or equivalent and terminated at each endwith N.E.C. approved grounding device.4. Appliance must be installed with an approved UL103 HTventilated chimney connector, UL103 HT chimney, andterminal cap with spark arrestor. Never use a single wallconnector (stove pipe) in a mobile home installation. Useonly double-wall connector pipe, Dura-Vent DVL, Selkirkmetalbestos DS or Security DL double-wall connector orany listed double-wall connector pipe.5. In Canada, this appliance must be connected to a 6 inch(152mm) factory-built chimney conforming to CAN/ULC-629M, STANDARD FOR FACTORY BUILT CHIMNEYS.6. Follow the chimney and chimney connector manufacturer’sinstructions when installing the flue system for use in amobile home.7. Maintain clearance to combustibles.8. Floor protection requirements must be followed precisely.9. Use silicone to create an effective vapor barrier at thelocation where the chimney or other component penetratesto the exterior of the structure.NOTE: Offsets from the vertical, not exceeding 45°, areallowed per Section 905(a) of the Uniform Mechanical Code(UMC). Offsets greater than 45° are considered horizontal andare also allowed, providing the horizontal run does not exceed75% of the vertical height of the vent. Construction, clearanceand termination must be in compliance with the UMC Table9C. This installation must also comply with NFPA 211.NOTE: Top sections of chimney must be removable to allowmaximum clearance of 13.5 feet (411cm) from ground levelfor transportation purposes.10. Burn wood only. Other types of fuels may generatepoisonous gases (e.g., carbon monoxide).11. If unit burns poorly while an exhaust blower is on in home,(i.e., range hood), increase combustion air.12. Installation shall be in accordance with the ManufacturersHome & Safety Standard (HUD) CFR 3280, Part 24.Approved for USA Installation only!6 Mobile Home Installation

/ 20

Related manuals for Quadra-Fire Explorer II Medium