Quadra-Fire EXPLRMED-PBK Instruction Manual

Contents

Quadra-Fire EXPLRMED-PBK Instruction Manual Manual pdf 4 page image

4 7061-197D November 7, 2014Explorer II Medium Wood StoveInstall Guide2 Getting StartedA. Design and Installation ConsiderationsConsideration must be given to:• Safety• Convenience• Traffic flow• Chimney and chimney connector requiredIt is a good idea to plan your installation on paper, using exactmeasurements for clearances and floor protection, beforeactually beginning the installation. If you are not using anexisting chimney, place the appliance where there will be aclear passage for a factory-built listed chimney through theceiling and roof.We recommend that a qualified building inspector and yourinsurance company representative review your plans beforeand after installation.If this appliance is in an area where children may be near it isrecommended that you purchase a decorative barrier to goin front of the appliance. Remember to always keep childrenaway while it is operating and do not let anyone operatethis appliance unless they are familiar with these operatinginstructions.B. Fire SafetyTo provide reasonable fire safety, the following should begiven serious consideration:1. Install at least one smoke detector on each floor ofyour home to ensure your safety. They should belocated away from the heating appliance and closeto the sleeping areas. Follow the smoke detectormanufacturer’s placement and installation instructions,and be sure to maintain regularly.2. A conveniently located Class A fire extinguisher tocontend with small fires resulting from burning embers.3. A practiced evacuation plan, consisting of at least twoescape routes.4. A plan to deal with a chimney fire as follows:In the event of a chimney fire:a Evacuate the house immediatelyb. Notify fire departmentWARNING• DO NOT CONNECT THIS UNIT TO A CHIMNEYFLUE SERVICING ANOTHER APPLIANCE.• DO NOT CONNECT TO ANY AIR DISTRIBUTIONDUCT OR SYSTEM.May allow flue gases to enter the house.Asphyxiation Risk.• Installation and use of any damaged appliance.• Modification of the appliance.• Installation other than as instructed by Hearth & HomeTechnologies.• Installation and/or use of any component part not approvedby Hearth & Home Technologies.• Operating appliance without fully assembling all components.• Operating appliance without legs attached (if supplied withunit).• Do NOT Overfire - If appliance or chimney connector glows,you are overfiring.Any such action that may cause a fire hazard.WARNINGFire Risk.Hearth & Home Technologies disclaims anyresponsibility for, and the warranty will bevoided by, the following actions:Check building codes prior to installation.• Installation MUST comply with local, regional, state andnational codes and regulations.• Consult insurance carrier, local building, fire officials orauthorities having jurisdiction about restrictions, installationinspection, and permits.CAUTIONNOTICE: HEARTH & HOME TECHNOLOGIES ASSUMES NORESPONSIBILITY FOR THE IMPROPER PERFORMANCEOF THE APPLIANCE SYSTEM CAUSED BY:• Inadequate draft due to environmental conditions• Downdrafts• Tight sealing construction of the structure• Mechanical exhausting devices• Overdrafting caused by excessive chimney heights• Ideal performance is with height of chimney between 14-16 feet(4.26-4.88m) measured from the base of the appliance.