517 August, 2018 7075-177AVOYAGEUR GRAND AUFigure 5.11. Remove box and 51mm x 102mm structural boardsbeing careful not to damage product.2. Using 7/16 socket or wrench remove one bolt locatedinside front part of appliance (Figure 5.1).3. Moving to the back of the appliance and using 7/16socket or wrench remove two bolts (Figure 5.1).4. Carefully pull appliance off of pallet and put in desiredlocation following Hearth Pad and Clearance toCombustibles on pages 8 and 9.F. Removal of Appliance from ShippingMaterials23D. Tools And Supplies NeededBefore beginning the installation be sure the following toolsand building supplies are available:To minimize the effects of negative air pressure:• Install optional outside air kit with the intake facingprevailing winds during the heating season• Ensure adequate outdoor air for all combustionappliances and exhaust equipment• Ensure furnace and air conditioning return vents arenot located in the immediate vicinity of the appliance• Avoid installing the appliance near doors, walkways orsmall isolated spaces• Recessed lighting should be a “sealed can” design• Attic hatches weather stripped or sealed• Attic mounted duct work and air handler joints andseams taped or sealed• Basement installations should be avoidedReciprocating sawPliersHammerPhillips screwdriverFlat blade screwdriverPlumb lineLevelMisc. screws and nailsFraming materialHigh temp caulking materialGlovesFraming squareElectric drill and bitsSafety glassesTape measure7/16 socket or wrench1/2-3/4 in. length, #6 or #8 self-drilling screws• Installation and use of any damaged appliance.• Modification of the appliance.• Installation other than as instructed by Hearth &Home Technologies.• Installation and/or use of any component part notapproved by Hearth & Home Technologies.• Operating appliance without fully assembling allcomponents.• Operating appliance without legs attached (ifsupplied with appliance).• Do NOT Over fire - If appliance or chimneyconnector glows, you are over firing.Any such action that may cause a fire hazard.WARNINGFire Risk.Hearth & Home Technologies disclaims anyresponsibility for, and the warranty will bevoided by, the following actions:• Remove appliance and components from packagingand inspect for damage.• Report to your dealer any parts damaged in shipment.• Read all the instructions before starting the installation.Follow these instructions carefully during the installationto ensure maximum safety and benefit.E. Inspection of Appliance and ComponentsFire Risk.Inspect appliance and components for damage.Damaged parts may impair safe operation.• Do NOT install damaged components.• Do NOT install incomplete components.• Do NOT install substitute components.Report damaged parts to dealer.WARNING