Quadra-Fire QFI30-C Owner's Manual

Contents

Quadra-Fire QFI30-C Owner's Manual Manual pdf 29 page image

29Quadra-Fire • QFI30-C, QFI35-C • 2227-901 Rev. H • 7/12PLUG120V EXISTINGOUTLETGRN (2)BLK (2)BLK (2)GRN (2)BLK (2)STEPS3 & 4WHT (2)BLOWERSPEED CONTROL(RHEOSTAT)SENSOR SWITCHSTEPS1 & 2STEP 5BLOWERSBLOWERRECEPTICLEBLKGRNBLKBLKGRNBLKWHTGRNBLKBLKGRNWHTBLKBLKPLUG INTO 120VEXISTING OUTLETDC REGULATORRECEPTICLEAUX 300 MODULEFANTO CONTROLMODULEFUSE WIREASSEMBLYFUSE WIREASSEMBLYD. Fan Wiring with RemoteThis appliance may be used with an RC200 or RC300remote control. See Figure 10.3.1. Remove cord assembly spades from rheostat andsensor switch.NOTICE: Fan speed and operation are controlled by theremote control. The sensor switch and rheostat are nolonger needed.2. Plug two cord assembly spade connectors together.3. Unplug fan cord assembly from standard cord assembly.4. Plug fan cord assembly into AUX300 module.5. Plug AUX300 module into the standard cord assembly.NOTE: USE ZIP TIES TO RESTRAINTHE LOOSE WIRES UNDERNEATHTHE APPLIANCE AND KEEP THEMAWAY FROM THE BLOWER WHEEL(FAN BLADES).NOTE: IF ANY OF THE ORIGINALWIRE AS SUPPLIED WITH THEAPPLIANCE MUST BE REPLACED,IT MUST BE REPLACED WITH TYPE105 0 C RATED WIRE.E. Control Module OperationSee Section 2.H for control module operation instructions.Figure 10.3 Wiring Diagram - Fan with RC200/RC300 RemoteNOTE: SENSOR SWITCH ANDRHEOSTAT SPEED CONTROL MUSTBE REMOVED FROM CIRCUIT IFSYSTEM IS CONTROLLED WITHRC200/RC300 REMOTE.