Quadra-Fire QFI30-C Owner's Manual

Also see for QFI30-C: Owner's manual

Contents

Quadra-Fire QFI30-C Owner's Manual Manual pdf 13 page image

13Quadra-Fire • QFI30-C, QFI35-C • 2227-901 Rev. S • 2/16VentingFrequency: SeasonallyBy: HomeownerTools needed: Protective gloves and safety glasses.• Inspect venting and termination cap for blockage orobstruction such plants, bird nests, leaves, snow, debris,etc.• Verify termination cap clearance to subsequent construc-tion (building additions, decks, fences, or sheds). SeeSection 6.• Inspect for corrosion or separation.• Verify weather stripping, sealing and flashing remainsintact.• Inspect draft shield to verify it is not damaged or missing.B. Maintenance Tasks-Service TechnicianThe following tasks must be performed by a qualifiedtechnician.Gasket Seal and Glass Assembly InspectionFrequency: AnnuallyBy: Service TechnicianTools needed: Protective gloves, drop cloth and a stablework surface.• Inspect gasket seal and its condition.• Inspect fixed glass assembly for scratches and nicks thatcan lead to breakage when exposed to heat.• Confirm there is no damage to glass or glass frame.Replace as necessary.• Verify that fixed glass assembly is properly retained andattachment components are intact and not damaged.Replace as necessary.LogsFrequency: AnnuallyBy: Service TechnicianTools needed: Protective gloves.• Inspect for damaged or missing logs. Replace as necessary.Refer to Section 12 for log placement instructions.• Verify correct log placement and no flame impingementcausing sooting. Correct as necessary.FireboxFrequency: AnnuallyBy: Service TechnicianTools needed: Protective gloves, sandpaper, steel wool,cloths, mineral spirits, primer and touch-up paint.• Inspect for paint condition, warped surfaces, corrosionor perforation. Sand and repaint as necessary.• Replace appliance if firebox has been perforated.Control Compartment and Firebox TopFrequency: AnnuallyBy: Service TechnicianTools needed: Protective gloves, vacuum cleaner, dustcloths• Vacuum and wipe out dust, cobwebs, debris or pet hair.Use caution when cleaning these areas. Screw tips thathave penetrated the sheet metal are sharp and shouldbe avoided.• Remove all foreign objects.• Verify unobstructed air circulation.