Quadra-Fire QVI30S Owner's Manual

Quadra-Fire QVI30S Owner's Manual Manual pdf 30 page image

Quadra-Fire • QVI30S, QVI35S • 340-901 Rev. i • 6/0930C. Check Pilot Flame AppearancePilot flame must contact the thermocouple and thermopilefor reliable appliance operation.• Pilot flame should be as shown in Figure 12.1.D. After Appliance is LitInitial Break-in ProcedureWhen you light the appliance, you may notice that it pro-duces heat which does have an associated odor or smell.If you feel this odor is excessive it may require the initialthree to four hour continuous burn on high followed by asecond burn up to 12 hours to fully drive off any odor frompaint and lubricants used in the manufacturing process.Condensation of the glass is normal.Note: The appliance should be run three to four hourson the initial start-up. Turn it off and let it cool completely.Remove and clean the glass. Replace the glass and runthe appliance for an additional 12 hours. This will help tocure the products used in the paint and logs.During this break-in period it is recommended that somewindows in the house be opened for air circulation. This willhelp avoid setting off smoke detectors, and help eliminate anyodors associated with the appliance’s initial burning.Figure 12.1 Proper Pilot Flame• If adjustment is needed remove cap screw from gas valveusing 1/8 inch standard screwdriver (see Figure 12.2).• Turn adjustment screw clockwise to increase pilot flamesize. Make small adjustments.Figure 12.2 Adjustments• Do NOT turn adjustment screw counter-clockwise too faras it will come out of the valve allowing gas to escape.• Replace cap screw and seal to prevent gas leaks.• Check for gas leaks after tightening.Glass door must be in place whenappliance is operating.Risk of:• Combustion Fumes• FireDo NOT operate appliance with glassdoor removed.• Open viewing glass for servicing only.• Glass door MUST be in place and sealed before operatingappliance.• Only use glass door certified for use with appliance.• Glass replacement should be done by qualified technician.WARNINGPILOTADJUSTMENT