Quadra-Fire iLLAGE QV32-A Installer's Manual

Contents

Quadra-Fire iLLAGE QV32-A Installer's Manual Manual pdf 32 page image

36Installing the TrimCombustible materials may be brought up to the specifiedclearances on the side and top front edges of the fireplace,but MUST NEVER overlap onto the front face. The jointsbetween the finished wall and the fireplace top and sidescan only be sealed with a 300° F. (149° C) minimum sealant.WARNING: WHEN FINISHING THE FIREPLACE,NEVER OBSTRUCT OR MODIFY THE AIR INLET/OUTLET GRILLES IN ANY MANNER.Install optional marble and brass trim surround kits asdesired. Marble, brass, brick, tile, or other non-combustiblematerials can be used to cover up the gap between thesheet rock and the fireplace.Do not obstruct or modify the air inlet/outlet grilles. Whenoverlapping on both sides, leave enough space so that thebottom grille can be opened and the trim door removed.!Step 10. Installing Trim, Logs andEmber MaterialPlacing the Ember MaterialEmber material is shipped with this gas fireplace. The baglabeled Mystic Embers is standard glowing ember material.To place the ember material:• Remove the top louver by lifting it up and away from the unit.• Unlatch the latches at the top and bottom of the glass door.• Remove the glass door from the unit (see Figure 45).• Place dime size pieces of ember material about 1/2 inchapart near port holes in burner top. Do NOT press em-bers into burner ports. Cover the top of the burner with asingle layer of ember material (see Figure 46).• Save the remaining ember materials for use during fire-place servicing. The bag of embers provided is sufficientfor 3 to 5 applications.• Reinstall and latch the glass door and top louver on the unit.Figure 46. Placement of the Ember MaterialFigure 45. Glass AssemblyPositioning the LogsIf the gas logs have been factory installed they should notneed to be positioned. If the logs have been packagedseparately, refer to the instructions that accompany thelogs. Save the log instructions with this manual.If sooting occurs, the logs might need to be repositionedslightly to avoid excessive flame impingement.GLASS SPECIFICATIONS:QV36-A 24 5/8 x 35 3/8 CERAMICQV32-A 21 1/8 x 30 3/8 CERAMICEMBER MATERIALSLATCHES(BOTH TOPAND BOTTOM)GLASSASSEMBLYCAUTION: THE GLASS DOOR MUST BE SECURELYLATCHED BEFORE OPERATING THE UNIT.______________________________________________________________________________________Shutter SettingsModel NG LPQV32-A 3/16” SETQV36-A 1/4” SETFigure 43Replace the logs referring to your manual and log instruc-tions.Position the right wall all the way to back wall. Secure inposition as was done in Step 2 (see Figure 44).Figure 44