Qualstar Q40 Installation And Operation Manual

Also see for Q40: Quick start guide

Contents

Qualstar Q40 Installation And Operation Manual Manual pdf 138 page image

Q40 Tape Library Installation and Operations Manual511026 Rev. 07-01-19 1387.10.5 After the Robotic Assembly and Spooling Mechanism Installation1. Push the left magazine back into the module until it locks into place.2. Replace the top cover on the Base Module if you removed one3. Slide the module into the rack.4. If there are no adjacent modules, tighten the front screws.5. If there are adjacent modules:Set the alignment mechanisms to the lock position. If you encounter resistance, adjust theupper module so the pin in the alignment mechanism moves into the hole in the lower module.6. Reconnect the expansion interconnect cables.7. Reconnect the Ethernet, SAS, and Fibre Channel cables to the Base Module.8. Reconnect the power cords.9. Pack the failed robotic assembly and spooling mechanism to return to Qualstar Technical Support.7.10.6 Powering On the LibraryPower on the library by pressing the power button on the Base Module just below the OCP; the greenlight will illuminate. When the library is powered on, it inventories the tape cartridges in the magazines,checks the firmware version on all modules, configures the tape drives, confirms the presence of theexisting modules, and searches for any new modules.7.10.7 Verifying the Installation1. To verify that the library powers on and initializes correctly, check that the status LED is Ready.2. If the UID LEDs are still illuminated, deactivate them using the RMI.3. Resume all host applications.7.11 Replacing the Front Bezel or OCPCAUTION Parts can be damaged by electrostatic discharge. Keep parts inelectrostatic containers until needed. Ensure you are properlygrounded when touching static sensitive components.7.11.1 Powering Off the LibraryPower off the library from the front panel. Press and hold the power button for 3 seconds. If the librarydoes not perform a soft shutdown, press and hold the power button for 10 seconds.Verify that the robotic assembly is in its parked position.Verify that all host processes are idle.7.11.2 Removing the BezelRemove the magazines.Insert a small flat head or Torx screwdriver into the bezel release holes at bottom of the unit.Push the screwdriver until the bezel is released.Pull the bezel upNOTE If removing a Base Module bezel, pull gently to avoid damaging the OCPcable. Note where the OCP cable is located, routed and attached.