Installing the LTO Driver Software 7LTO-4 Half-Height Tape DriveConnect the interface and AC power cables to the tabletop drive as follows:1 As required:a Save and close your open files and terminate all running applications.b Shut down the workstation or server system.c Disconnect the system AC power cord from the facility AC power receptacle.2 Attach the external SAS interface cable to the 26-pin SFF-8088 mini-SAS connector onthe back of the drive.3 Verify that the tabletop LTO-4 Half-Height Tape Drive AC power switch is set to theoff position, and connect the AC power cord to the power connector on the back of thedrive.4 Connect the drive AC power cord to the facility AC power receptacle.5 Reconnect the workstation or server system AC power cord to the facility AC powerreceptacle.After connecting the tabletop drive interface and AC power cables, proceed to Restartingthe Tabletop Tape Drive System in the following subsection.Restarting the TabletopTape Drive System 0 After connecting the tabletop drive interface and AC power cables:1 Set the tabletop drive AC power switch to the on position.2 Restart the workstation or server system.3 Verify that the tabletop LTO-4 Half-Height Tape Drive comes on and completes thePower On Self Test (POST) functions.As required, proceed to either:• Installing the LTO Driver Software• Registering the LTO-4 Half-Height Tape DriveInstalling the LTO Driver SoftwareIf you intend to use the LTO-4 Half-Height Tape Drive with the Microsoft® native backupapplet on a Windows 2000, Windows Server ® 2003, Windows XP ®, or Windows Vistaoperating system, install the appropriate version of the LTO driver software. (See theDownloads page for LTO-4 drivers under Standalone Tape Drives on the Quantumsupport website at: www.quantum.com/support.)Note: The LTO driver software is not necessary with commercial backup applicationsoftware.