Quark-Elec QK-A051T Manual
Also see for QK-A051T: Setup guide
                  | |
Contents
| 
Quark-elec Manualhttps://www.quark-elec.com 11 of 18 2019V1.03.4.1. WiFi: Ad-hoc modeOn your device (phone, laptop etc):15 seconds after the A051T has powered up, scan from your device (phone, tablet, laptop) for a WiFi network with anSSID similar to ‘QK-A051Txxxx’. Connect with the default password: ‘88888888’.In your chart software: Set the following connection settingsWith the above settings, a wireless connection should be established and the user will be able to view their datathrough the chart software.Note: In Ad-hoc mode, the IP address should not be changed.The Ad-hoc password can be changed using the configuration tool.The password should be between 8 to 12 characters.If changed, all users wishing to connect Ad-hoc to the A051T will need the new password.3.4.2. WiFi: Station modeStation mode WiFi allows your Access Point/router to handle the data and traffic from your device. This data can thenbe picked up through your router anywhere on your local area network.This allows your mobile device view AIS and GPS information wirelessly while still receive your other AP functionalityincluding internet if relevant.Station mode is set up through the Configuration software. See the Configuration Chapter.3.4.3. WiFi: StandbyThe user can switch off the WiFi output by selecting ‘Standby’ mode if desired. See the Configuration Chapter.3.4.4. WiFi data checkIf needed, the user can always check the wireless connection with a TCP/IP port monitoring software as shown below:Device SSID Similar to ‘QK-A051Txxxx’Default WiFi password 88888888Device SSID Similar to ‘QK-A051Txxxx’Protocol TCPIP address 192.168.1.100Data Port 2000 |
Related manuals for Quark-Elec QK-A051T
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine