Quatech AirborneDirect ABDB-ET Series User Manual
                                                                             | |
Contents
| 
100-8007-141G AirborneDirect™ Ethernet Bridge User's Guide Page 19Quatech, Inc. ConfidentialCHAPTER 3INITIAL CONFIGURATIONThis chapter describes configuring the AirborneDirect™ Ethernet Bridge. Topics in this chapterinclude: Wireless Configuration. (below) Verifying Your Connections (page 20) WPA-LEAP Security. (page 20)WIRELESS CONFIGURATIONAfter you verify that the indicator LEDs have gone through their power-up sequence, start theconfiguration application for your Access Point (your Access Point manual should describe thisprocedure). Then go the appropriate screen in the application and perform the following steps:Note:Access Point configuration applications vary between models andmanufacturers. In the following steps, there are suggested screen names whereyou might find the Access Point settings required to operate the Bridge. Thescreens in your Access Point’s configuration application may differ from thosementioned below. Refer to the documentation that came with your Access Pointto locate the appropriate screens where these settings can be accessed.• Find the Service Set Identifier String (SSID)Go to the Wireless Settings or equivalent screen in your Access Point’s configurationapplication that shows the Access Point’s SSID. Record the SSID in Table 4 (onpage 20). You will need this information to configure the Bridge.• Disable Wireless SecurityGo to the Wireless Settings, Security, Encryption, or equivalent screen in yourAccess Point’s configuration application that shows the WEP/WPA setting. If WEP orWPA is enabled, disable it (you can enable the AP security after the Bridge has beenconfigured).• Find the Bridge’s Internet Protocol (IP) AddressGo to the Attached Devices or equivalent screen in your Access Point’s configurationapplication that lists the IP addresses of devices attached to the Access Point. Findthe IP address for the Bridge and record it in Table 4 (on page 20). You will need it toaccess the Bridge with the Airborne Control Center (ACC). |
Related manuals for Quatech AirborneDirect ABDB-ET Series
manualsdatabase
Your AI-powered manual search engine