2.1.3 Common ProblemsGeneric Client Drivers:Many Card and Socket Services packages include a generic client driver(or SuperClient) which configures standard I/O devices. If one of thesegeneric client drivers is installed, it may configure the SPP-100 causingthe SPP-100 client driver to fail installation. In these cases, the usershould do one of the following:1. modify the operation of the generic client driver to disable theconfiguration of parallel port cards. Consult the Card andSocket Services documentation for availability and details ofthis feature.2. place the SPP-100 client driver before the generic client driverin the CONFIG.SYS.Available Resources:One function of the Card and Socket Services software is to track whichsystem resources (memory addresses, I/O addresses, IRQs, etc.) areavailable for assignment to inserted PCMCIA cards. Sometimes,however, the Card Services software assumes or incorrectly determinesthat a particular resource is used when it is actually available. Most Cardand Socket Services generate a resource table in a file (typically in theform of an .INI file) which the user can modify to adjust the availablesystem resources. Consult the Card and Socket Services documentationfor availability and details of this feature.Multiple Configuration Attempts:Some Card and Socket Services have a setting which aborts theconfiguration process after a single configuration failure (such as arequest for an unavailable resource). The user should change this settingto allow for multiple configuration attempts. Consult the Card and SocketServices documentation for availability and details of this feature.Older Versions of Card and Socket Services:Some versions of Card and Socket Services dated before 1993 do notsupport general purpose I/O cards. If after careful installation of theClient Driver the SPP-100 does not configure or operate properly, anupdated version of Card and Socket Services may be required. Card andSocket Services software is available from Quatech.SPP-100 User's Manual 2-7