Quickie SR 45 Instructions For Use Manual

Also see for SR 45: Owner's manual Instructions for Initial Assembly Owner's manual

Quickie SR 45 Instructions For Use Manual Manual pdf 20 page image

enGLISh20 SR45 Rev.1.04.0 SetuP AnD ADJuStMentNOTE: Setting the wheelchair on a table or on a flatsurface, such as a workbench, helps make theseprocedures easier.Torque SettingA torque setting is the optimum tightening which shouldbe made on a particular fastener. A torque wrench whichmeasures Nm should be used when tightening fastenerson Quickie wheelchairs. Unless otherwise noted, use atorque setting of 6.8 Nm. When setting up thiswheelchair.70º, 80° SWING-IN/SWING-OUT hANGERS ANDfootReStS(fIG.4.0-4.1)InstallationPlace swing-in/swing-out pivot saddle into the•receiver on front frame tube with the footrest facinginward or outward from the frame.Rotate the footrest inward until it locks into place on•locking bolt.RemovalTo remove footrest, release latch by pulling lever•upward or pushing lever downward.Rotate footrest inward or outward and lift.•height AdjustmentNOTE: It is recommended that you maintain a minimumof 51mm between the lowest point on the footrest andthe floor.Loosen set screw (C) using a 3/16 inch hex key.•Slide footrest extension up or down inside frame tube•to desired height.Tighten set screw. Use a torque setting of 144 in-lbs•(16.27 Nm).ELEVATING LEGREST (OPTIONAL)(Fig.4.2).Installation or RemovalTo install or remove Elevating Legrest (ELR) see•instructions for Swing-away Footrestinstallation above.Elevation AdjustmentTo raise legrest, lift to desired position. Legrest will•automatically lock in place.To lower legrest, while seated in chair, press release•lever (G) down and lower legrest to desired position.Legrest will automatically lock in place.cFig.4.1Fig.4.0ABFig.4.2GhIheight Adjustment of the Calf PadLoosen the retaining nut (H) located at the back of•the calf pad bracket assembly.Slide the calf pad bracket assembly up or down.•Tighten it in the desired position.•height Adjustment with Extension TubeNOTE: It is recommended that you maintain a minimumof 2.0 inches between the lowest point on the footrestand the floor.Loosen set screw (I) using a 3/16 inch hex key.•Slide footrest extension up or down inside frame tube•to desired height.Tighten set screw. Use a torque setting of 144 in-lbs•(16.27 Nm).