Quickie SR 45 Instructions For Use Manual

Also see for SR 45: Owner's manual Instructions for Initial Assembly Owner's manual

Quickie SR 45 Instructions For Use Manual Manual pdf 26 page image

enGLISh26 SR45 Rev.1.0CARRIAGE (fIG.4.26-4.28)WARnInG!This adjustment must be done by an authorized supplieronly.Location Adjustment (fig.4.26).Loosen and remove bolts A & B.•Move carriage to desired location.•Replace and tighten all bolts.•cAutIon!The adjustment on each side of the chair should beexactly equal.Use a torque setting of 14Nm (120 in.-lbs). When setting-up carriage.Top Roller Replacement (fig.4.27)cAutIon!It is highly recommended to replace both top rollers•within each carriage assembly at the same time.Do not use lubricants anywhere on the assembly.•To replace the top roller:Loosen both plunger pin bracket nuts.•Loosen and remove both lower roller nuts (J), chassis•fastener nut (C), and base strut bolts (D) on bothsides. Remove base strut.Slide the inner carriage plate (E) off the fasteners,•towards the center of the chair.Loosen and remove both button head roller screws•(F).Remove old top rollers (G) from the upper roller•shafts (H) and replace with new top rollers.Reinstall the upper roller shafts (H) onto the inner•carriage plate (E), installing button head screws (F).Reinstall the carriage plate (E) onto the frame•assembly. Replace and tighten the nuts (J, C) and strutbolts (D).Ensure that the plunger pin is centered and engaged•into a rocker hole and tighten plunger pin bracketnuts.Repeat on the other side of chair as necessary.•bottom Roller Replacement (fig.4.27-4.28)cAutIon!It is highly recommended to replace both bottom•rollers within each carriage assembly at the sametime.Do not use lubricants anywhere on the assembly.•• Use a torque setting of 150 in.-lbs. when tighteningbottom roller nuts (J).To replace the bottom roller:Loosen both plunger pin bracket nuts.•Loosen and remove both lower roller nuts (J), chassis•fastener nut (C), and base strut bolts (D).Slide the inner carriage plate (E) off the fasteners,•towards the center of the chair.Remove old bottom rollers (I) from the roller bushings•(K) and replace with new bottom rollers.Reinstall the carriage plate (E) onto the frame•assembly. Replace and tighten the nuts (J, C) and strutbolts (D).Ensure that the plunger pin is centered and engaged•into a rocker hole and tighten plunger pin bracketnuts.Repeat on the other side of chair as necessary.•WheeL LocKSNOTE: Quickie wheelchairs are standard with wheellocks. Wheel locks are installed at Sunrise Medicalunless omitted from the original order.Adjustment (fig.4.29)Loosen the screws (L). Do not attempt to remove one•screw at a time.Slide assembly toward rear wheel until clamp•embeds into tire to prevent wheel movement, when inlocked position.Tighten screws.•Fig.4.26BAFig.4.29LFig.4.27cIhGf eDJFig.4.28I K