118611 Rev. B 14IX. SET-UP & ADJUSTMENTABCDFGIJ JIHC. CASTER/FORKS ASSEMBLY1. Installationa. Remove dust cover (A) from caster housing. Pry cover off using a back and forth motion.b. Caster assembly holds one nut (B) and one washer (immediately below the nut).Remove nut and washer.c. Insert caster stem (C) into caster housing (D) and place washer on stem.d. Replace nut (B) on caster stem and tighten until all play is removed; then loosen approx-imately 1/8 turn, allowing for free rotation.e. Replace dust cover to caster housing.2. Height Adjustmenta. Loosen and remove bolt (F).b. Set axle at desired height using pre-set holes in the fork.c. Replace and tighten bolt.d. Repeat on other side.NOTE– The frame must be kept horizontal when height is adjusted. Refer to Section O-7 for rear axleheight adjustment.D. DUAL-POST ARMRESTS1. Installation or Removala. The assembly is held securely in place when the securing lever (G) is facing rearward.b. Push front securing lever (G) down to release, or lift transfer bar lever (H), whicheveris present.c. Completely press lever (I) inward on rear post.d. Lift armrest out of receivers.2. Height-Adjustmenta. Release the upper securing lever (J).b. Set armrest at desired height.c. Return securing lever to locked position.d. Move armrest up or down to allow armrest to snap into place.3. Flip Back (optional)a. Release the front securing lever (G) or lift up transfer bar lever (H), whichever is pres-ent.b. Flip the armrest back, it remains attached to the rear receiver.c. To detach armrest completely press lever (I) inward on rear post and lift up.d. To reattach, move armrest down into place.e. Return securing lever (G) to locked position (if applicable).E. HEIGHT-ADJUSTABLE ARMRESTS (optional)1. Installationa. Slide the outer armpost into the receiver mounted to the wheelchair frame.b. The armrest will automatically lock into place.2. Height Adjustmenta. Rotate release lever to second stop.b. Slide armrest pad up or down to desired height.c. Return lever to locked position against armpost.d. Push arm pad until upper armpost locks firmly into place.3. Removing Armresta. Rotate release lever to first stop and remove the armrest.4. Replacing Armresta. Slide armrest back into receiver.b. Return release lever to locked position against armpost.5. Adjusting Armrest Receiver FitTo tighten or loosen the fit of the outer armpost in the receiver:a. Loosen the bolts on the sides of the receiver (9).b. With the armrest in the receiver, squeeze the receiver to achieve the desired fit.c. Tighten the four bolts.6 6a55554 451. Outer armpost2. Release Lever–Height3. Release lever4. Armrest pad5. Transfer bar6. Side panel7. Receiver8. Clamp9. Receiver adjustmenthardware1362597646a789E N G L I S H