Quickie sr45 Owner's Manual

Also see for SR 45: Instructions for use Instructions for Initial Assembly Owner's manual

Quickie sr45 Owner's Manual Manual pdf 16 page image

118611 Rev. B 16E N G L I S HEFGHIAB15161718A B13DC144. Cable AdjustmentNOTE– Do not use lubricants on the components or assembly.a. Loosen the jam nut (A).b. Rotate the cable adjuster (B) until slack is removed from the cable. Make sure theplunger pin can fully extend and retract after adjustment and that pins engage the rock-er when triggers are released.c. Tighten jam nut (A).H. BACKREST AND STROLLER HANDLE1. Angle Adjustmenta. Loosen rear bolt (C).b. Loosen and remove angle adjustment bolt (D).c. Set backrest at desired angle using pre-set holes.d. Replace and tighten the angle adjustment bolt (D).e. Tighten rear bolt (C).f. Repeat on other side.IMPORTANT NOTE– The adjustment on each side of the chair should be exactly equal.NOTE– Use a torque setting of 120 in.-lbs. When setting-up the angle adjustment of the stroller handle.NOTE– Backrest position may also need adjusting to maintain optimal CG alignment and stability.2. Angle Adjustment of the Stroller Handle (optional)Depress both black push buttons (E) at the same time. This disengages the stroller handle andallows it to rotate freely. Releasing the push buttons positively locks the adjustable stroller han-dle in the desired position.3. Height Adjustment (optional)a. Remove both bolts (F) from the backrest tube (one on each side).b. Reposition backrest height.c. Re-tighten both bolts (F) in the desired location.NOTE– Both sides must be at the same height.NOTE– It is not recommended to align the top hole in the lower tube with the bottom hole in the uppertube, as excess play may result.4. Flip-Down Back Function (optional)a. To fold the back down, pull-up the back release pins (G) and push the backrest for-ward.b. To lock it back in position, lift the backrest firmly until it locks in its original position.I. STROLLER HANDLE EXTENSION (optional)Installationa. Press button (H) simultaneously on both sides of the stroller handle so that release pinsare drawn inside the tube.b. Insert the tube into the back tube receiver (I) until the release pin protrudes throughthe receiver mounting hole.J. RECLINING BACK (optional)The dual trigger reclining mechanism is installed by Sunrise Medical.To Recline or Raise Backresta. Depress both triggers (A) at the same time. Releasing the triggers positively locks thebackrest in place.b. To lock out the adjustment system, insert the locking pin (B) into the trigger holder.Always lock the dual trigger reclining mechanism securely in place after positioning thebackrest.18171615151413IX. SET-UP & ADJUSTMENT