Qvis EYE-4MP-FG/W Installation & Network Connection Manual
                                                                    | |
Contents
| 
© Copyright Qvis Ⓡ All software and documentation rights reserved.152.2.2 Connection over LAN network (with DHCP server)The following steps will describe how to connect the camera to the NVRover a Local Area Network (LAN), via an external POE switch.These instructions need to be followed only if you are connecting thecamera to the NVR over a network that has a DHCP server apart of it.1. Connect the camera to a POE switch connected to the same networkthe NVR is connected to. The network will automatically assign thecamera an IP address in the same range as the rest of the network isset to.2. Connect an Ethernet cable from a PC or Laptop to an Ethernet portwithin the same network.3. Install the ‘Device Search’ software tool on to the PC or laptop (thesoftware will be on the ‘Resource’ disc that comes with the camera).4. When the software tool has been installed, click the ‘Search’ buttonto find the camera on the network. Note down the IP address for thatcamera (see image below). |
Related manuals for Qvis EYE-4MP-FG/W
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine