© Copyright Qvis ®. All documentation rights reserved. 1475.5 Image/Alarm-outSelect one monitor channel video and then click Image button in section 9, the interface is shownas Figure 5-10.5.5.1 ImageHere you can adjust its brightness, contrast, hue and saturation. (Current channel borderbecomes green).Or you can click Reset button to restore system default setup.Figure 5-105.5.2 Alarm outputHere you can enable or disable the alarm signal of the corresponding port. See Figure 5-11.Figure 5-115.6 Zero-channel EncodeSelect a window and then click zero-channel encode button, the interface is shown as below. SeeFigure 5-12.
