RAM 1500 2014 User Manual

Also see for 2014 2500 Tradesman: Information Catalog Owner's manual

Contents

RAM 1500 2014 User Manual Manual pdf 132 page image

PICKUP BOX• You can carry wide building materials (sheets of plywood, etc.) by building a raisedload floor. Place lumber across the box in the indentations provided above thewheel housings and in the bulkhead dividers to form the floor.• There are stampings in the sheet metal on the inner side bulkheads of the box infront of and behind both wheel housings. Place wooden boards across the box fromside to side to create separate load compartments in the pickup box.• There are four tie-down cleats bolted to the lower sides of the pickup box that cansustain loads up to 1000 lbs (450 kg) total.Cargo Camera• Your vehicle may be equipped with the Cargo Camera that allows you to see a imageof the inside of the pickup box. The image will be displayed in the Uconnect ® screen.• A display timer is initiated when the cargo camera image is displayed. The imagewill continue to be displayed until the display timer exceeds 10 seconds and thevehicle speed is above 8 mph (13 km/h) or the image is deactivated by touchingthe Uconnect® display.NOTE:If the vehicle speed remains below 8 mph (13 km/h), the cargo camera image will bedisplayed continuously until deactivated by touching the Uconnect® display.• The Cargo Camera is located in the bottom center area of the center high-mountedstoplamp (CHMSL).NOTE:If snow, ice, mud, or any foreign substance builds up on the camera lens, clean thelens, rinse with water, and dry with a soft cloth. Do not cover the lens.Turning Cargo Camera On Or Off — With Uconnect® 8.4A/8.4AN1. Touch the “Controls” soft-key located on the bottom of the Uconnect® display.2. Touch the “Cargo Camera” soft-key to turn the Cargo Camera system ON.UTILITY130