9Watching Video Equipment1. Connect the other equipment to the monitorusing a standard AV Cable (not included).2. Turn on the monitor.3. Turn on the video equipment and follow theinstructions provided with it to playback.Notes:• Make sure to use the correct Audio/Video cable.Connecting the plugs incorrectly may cause aweak signal.• If you have a mono VCR, the volume level fromthe speakers will be low.D. Connecting to Video Equipment (for the DVD Player Only)You can connect other video equipment for playback through the unit.E. Connecting Game Systems/Video Equipment (for the Monitor Only)You can connect game systems or other video equipment for playback through the monitor.C. Connecting a Stereo Receiver or Amplifier (for the DVD Player Only)The DVD player can play two channels Dolby Digital.Listening on External Audio Equipment1. Connect the DVD player to the left/rightAudio In jacks on the other equipmentusing a DC-AV cable.2. Turn on the DVD player and slide the AV IN/ DVD switch to the DVD position.3. Turn on your audio equipment and followthe instructions provided with it to selectthe AUDIO IN function.Notes:• Make sure to use the correct Audio cable. Connecting the plugs incorrectly may cause a weak signal.• If you have a stereo VCR, make sure you set it to stereo mode.• Due to copyright protection, DVD movies cannot be copied. If you copy a DVD movie onto a videotape, theresulting copy will be unclear, with poor sound quality. This is NOT caused by a defective DVD system.Watching Video Equipment1. Connect the DVD player to the left/right Audio In jacks on the other equipment using a DC-AV cable.2. Turn on the unit and slide the AV IN / DVD switch to the AV IN position.3. Turn on the video equipment and follow the instructions provided with it to playback.DVD PlayerDC-AV cableStereo Receiver /AmplifierDVD PlayerAV cable(not included)To AUDIO / VIDEOIN / OUT jacksVideoEquipment AUDIO OUTVIDEO OUTGame System /Video EquipmentMonitorAV cable(not included)