h@r mnf@rmati@nMaybe remote is not in TV Mode. Press the TV button so remote will control TV.Maybe batteries ill remote are weak, dead or ins[ailed incorrectly. Put new batteries ill the remote. (Note, if you remove the baneries,you may have to reprogram the remote _) operate other components.)YOU might need to drain the remote's microprocessor: remove batteries and press the number 1 button for at least 60 seconds.Release the 1 button, replace the batteries, and (if necessalT) program the remote again.PIP (Picture-In-Picture Feature) Doesn't WorkIf you press INPU [' to tune to the component connected to the INPU ['2 Y_ PE_,PR jacks, PIP is not awfilable.If you press INPUT to tune to the component connected to tile VPORT jack, PIP is not awfilable.Problems with V-Chip/Parental ControlsThe rating limits don't workYOUIT|US[lock the sunings. Go to the' "l't'MAl[_v_/ll?_N[[(pl'eSS MENU on your relTtOte) select t)ar_mtal C?)_Ttrols(pl'{_SS 6 ()1] yourremote), select Locle Parental Controlx (press 6 on your remote).I don't remember my password and I want to unlock the TVIf you forget your password simultaneously press and hokl MENU on the teh, visk)n and volume down on the remote for 3 seconds.Nothing app_'al"s on the' scre_,n Parental Controls simply unlock and you can re _,nter a password via Loclal'at_mtal C?)_trols.The V-Chip won't let me watch a program even though it's not rated as violent.Maybe tile movie' was given an NR (Not Rated) status. After you block movie ratings, you must set 3/1¢ to Vk_zt separately in order toview movies with an NR rating.Problems with VPORT ConnectionNo picturePress the' INPU [' button until |7_()RTrapp_ars on screen.If using tile Component vide() to VPORT cable, make sure tim cables to tim other component are connected correctly.If using tile Xbox to VPORT cable, make sure tile end labeled TV is connected to tile ['V and tile end labeled XBOX is connected tothe Xbox vide() game system. No other gaming device can be connected to the TV with this cable.No sound or poor soundIf using tile Component video to VPORT cable, make sure the red and white cabh's are c(mnectd to the Audio Output Jacks.If using file digital audio jack on file Xbox to VPORT cable, make sure the cabh' is fully connected to file jack and file audk) receiver.Care and CleaningCAUTION: Turn OFF your TV before cleaning.You can clean ll_e TV as required, using a soft lint-l_cee cloth. Be sure to occasionally dust the ventilation slots in the cabinetto help assure adequate ventilation.The TV's screen may be cleaned with a soft, lint-free cloth as well. Take care not to scratch or mar the screen. Ifnecessary, you may use a cloth dampened with warm water. Never use strong cleaning agents, such as anlmonia-based cleaners, or abrasive powder. These types of cleaners will damage the TV.While cleaning do not spray liquid directly on the screen, or allow liquid to run down the screen and inside the TV. Also,avoid placing drinks or vases with water on top of the TV. This could increase the risk of ['ire or shock hazard or damage tothe TV.Caution: [sing video gantes or any external accessory with fixed images tk)r extended periods of time can cause them tobe permanently imprinted on the picture robe (or projection TV picture tubes). ALSO, some network/prograln logos, phonenumbers, etc. may cause similar damage. This damage is not covered by your warranly.56