25Using the Remote3. Press and hold the button on the remote you want to program.4. Enter the code from the code list.5. Release button, and then press ON•OFF to see if the componentresponds to the remote commands. If it doesn’t, try pressing thecomponent button and then ON•OFF again.6. If you get no response, repeat these steps using the next code listedfor your brand, until the component responds to the remotecommands.Using the Remote to Control a DeviceOnce the remote has been programmed successfully, you are ready touse it to control your devices.To operate the device:1. Press the device button (TV, VCR1, VCR2, AUX, or SAT•CABLE) to setthe remote to control the device.2. Press ON•OFF to turn the device ON or OFF.3. Use the remote buttons that apply to that device.Modes of OperationBecause this universal remote can control several different components(VCR, Cable Box, etc.) it uses operational modes triggered by thecomponent buttons. For example if you want the remote to control theTV, you would press the TV button to put the remote into TV modebefore you could control the TV.Front PanelIf you cannot locate your remote you can use the front panel of your TVto operate many of the TV’s features.MENU Brings up the Main menu. When in the menu system, it selectshighlighted items. Also returns you to the previous menu.CH v Scans down through the current channel list. In the menu system,it points down to items and adjusts menu controls.CH ^ Scans up through the channel list. In the menu system, it pointsup to items and adjusts menu controls.VOL – Decreases the volume. When in the menu system, VOL – is usedto point left to items and adjust menu controls.VOL + Increases the volume. When in the menu system, VOL + is usedto point right to items and adjust menu controls.POWER Turns the TV on and off.The Front Panel Block feature disables allfront panel buttons. For moreinformation, see “Parental Controls,” inthe Features and Menus section.