RCA L32HD36 User Manual

Also see for L26HD31 - 26" LCD TV: Specifications User guide Guía del usuario Guide de l'utilisateur

Contents

Using the Remote Control Chapter 2 27Programming the RemoteThe CANCEL button is used as visual feedback during the programming operation. Duringprogramming, the CANCEL button will light up when buttons are pressed and turn off whenbuttons are released. When programming is finished, the CANCEL button will long blink toindicate success and short blink to indicate fail.Note: All device buttons are off during programming mode.There are 3 ways to program the remote control to operate other devices: Direct Entry,Manual Code Search, and Automatic Code Search. If you have recently purchased the deviceyou want to control or if the device has many codes, you might want to try the manual codesearch first.Using Direct Entry1. Turn on the device you want to control.2. On your remote control, simultaneously press and hold the ON• OFF and MUTE buttons(approximately 3 seconds) until the CANCEL button lights up. Then release the buttons.3. Press and release the device button (SAT/AUX or DVD) you want to program.4. Enter a 4-digit code from the code list. The first digit indicates the database device type (0for DVD, 1 for Satellite TV, 2 for Cable, 3 for DVR, 4 for VCR, 5 for Audio, 6 for CD), theother 3 digits indicate the brand. Look up the brand and code number(s) for the device inthe code list at the end of this section.5. The CANCEL button will long blink to indicate success. Repeat these steps until you’vetested all codes for your device’s brand or try to run a manual code search.Using a Manual Code SearchNote: Before using manual code search, you must use Direct Entry first. This lets the remote knowwhich type of device to begin searching codes. Then proceed with the following steps.1. Turn on the device you want to control.2. On your remote control, simultaneously press and hold the ON•OFF and MUTE buttons(approximately 3 seconds) until the CANCEL button lights up. Then release the buttons.3. Press and release the device button (SAT/AUX or DVD) you want to program.4. Repeatedly press and release the left arrow or right arrow button, watching for the deviceto respond. If it does turn off, press and release the OK button to save the code. TheCANCEL button will long blink to indicate success.5. When all codes have been searched, the CANCEL button will short blink to indicate fail,then the remote returns to normal operation.Note: Use right arrow to search ahead, use left arrow to search back. Or you can press the ON/OFF button to switch to Auto Code Search mode.Using Automatic Code Search1. Turn on the device you want to control.2. On your remote control, simultaneously press and hold the ON•OFF and MUTE(approximately 3 seconds) buttons until the CANCEL button lights up. Then release thebuttons.3. Press and release the device button you want to program.4. Press and release the ON•OFF button once. The remote starts the code search.5. Once the device turns off, quickly press the OK button to save the code. The CANCELbutton will long blink to indicate success.6. When all codes have been searched, the CANCEL button will short blink to indicate fail,then the remote returns to normal operation.Note: If you accidentally passed the code before saving it, press the left arrow button to backtrackthrough the codes; then use the right arrow button to go forward through the codes again. Oncethe left arrow or right arrow button has been pressed, the search mode changes to Manual CodeSearch.