Connections and Setup14 Chapter 1Complete the Initial SetupThe menu system in your TV allows the TV’s features to work properly. The first time you turnon your TV, the language screen appears.Channel setupGo backSignal type Cable...Auto Channel search ...EnglishFrançaisEspañolSet the Menu LanguageThe first part of the setup allows you to select your preferred languagefor the menu system.If English is your preferred language, press OK. To choose anotherlanguage, press the down arrow button until that language ishighlighted, and press OK.Complete Channel SetupMake sure you've connected the TV to cable and/or an off-air signalbefore you start the next part of the setup.Set the Signal TypeIf you connected Cable to your ANTENNA/CABLE jack, the option ischosen for you and you can press the down arrow button to continue.To choose Antenna, press the right arrow button and then press thedown arrow button to continue.Channel setupGo backSignal type Cable...Auto Channel search Running...ProgressAnalog Channels found 10Digital Channels found 05Auto Channel search in progress. Press CLEAR to cancelAny channels already found will be stored.If you have analog and digital channels,the TV's search might take longer since it islooking for both.Complete the Channel SearchWith Auto Channel Search highlighted, press OK to begin the channelsearch.There are several things to be aware of when the TV's searchesfor channels.If you chose Cable as your signal type, the search takes a whilebecause it's looking for analog and digital channels, and then it'sremoving scrambled channels found. Here is what happens during thesearch:1. The search first looks for digital channels and places the numberof channels found next to Digital Channels found. This numberwill probably seem like a lot. This is because the number includesboth scrambled (for example, Pay Per View) and non-scrambledchannels. These channels are dependent upon what your cablecompany is sending.2. The search then looks for analog channels and places the numberof channels found next to Analog Channels found.3. The search might appear as if it is complete, but as long as thesearch says Running, it is still in progress. What's happening atthis point is the TV is removing scrambled channels from thechannel list. When the search is finally complete, the Channelsetup menu will look like the picture to the left. To exit the menusystem, press CLEAR.Channel setupGo backSignal type Cable...Auto Channel search ...Auto Channel search complete. Press OK to review channels.Press CLEAR to exit, MENU for Setup menu.Once a channel search is complete, theChannel setup menu looks like this.