Using the Remote Control22 Chapter 2Therefore, after you’ve successfully set up the Volume Punchthrough feature, whenever the TVremote is in DVD mode (press the DVD button) and you want to adjust the volume, you onlyhave to press the VOL +/- or MUTE buttons. Follow the instructions below to set up VolumePunchthrough.1. On your remote control, simultaneously press and hold the ON•OFF and MUTE buttons(approximately 3 seconds) until a device button remains lit. Then release the buttons.2. Press and hold the MUTE button until the device button blinks off, then release the MUTEbutton.3. Press and release the device button that you programmed to operate the audio system(receiver or amplifier).4. Press and release the MUTE button.5. Now, test it by turning on your audio system.6. Turn on the device that is connected to the audio system (satellite receiver, for example).7. Put the TV’s remote in SAT•AUX mode by pressing the SAT•AUX button.8. Press VOL+ or VOL-. The volume from the audio system should increase or decreaseaccordingly.Deleting ALL Volume Punchthrough CommandsTo delete all programmed Volume Punchthrough settings and return the remote control back tothe factory defaults:1. Simultaneously press and hold the ON•OFF and MUTE buttons (approximately 3 seconds)until a device button remains lit. Then release the buttons.2. Press and hold the MUTE button until the device button blinks off, then release the MUTEbutton.3. Press and release the MUTE button until the device button light turns off.4. The remote returns to normal Volume/Mute control.