RCA P50930 User Manual

PROG RAMMI NG TH E REMOTEThe universal remote can be programmed to control most brands ofremote controllable VCRs, satellite receivers and cable boxes. Theremote is already programmed to control most RCA, GE and PROSCANTVs, VCRs, DVD players, laserdisc players and satellite receivers.TESTING THE REMOTETo determine whether the universal remote needs to be programmed,turn a device ON, such as a VCR, point the remote at the VCR, and pressthe VCR1 'button. Then press POWER or CH ^ (channel up) or CH v(channel down) to see if the VCR responds to the remote commands. Ifnot, the remote needs to be programmed.PROGRAMMING THE REMOTEUsing Automatic Code SearchThe following instructions can be used to program the remote tocontrol each of the devices connected to your TV. If you want to exit theautomatic code search without programming any of your devices, pressCLEAR until the LED turns off.1.2..Turn on the device you want to control (VCR, SAT, etc.)Press and hold the button you want to program (VCR1, VCR2, etc.).While holding the device button, press and hold ONeOFF until thered light on the remote turns on, then release both buttons.Press and release PLAY, then wait 5 seconds or until the LED stopsflashing.At this point the remote is searching for the correct code toprogram. If, after 5 seconds, the device you want to control doesnot turn off, press PLAY again to tell the remote to search the nextset of codes.Continue pressing PLAY until the device turns off or you havesearched through all of the codes. There are 20 total sets of codes.If the device does not turn off after pressing PLAY 20 times, thenthe remote cannot control that particular device.If the device you want to control does turn off:1. Pressand release REVERSE,then wait 2 seconds. Repeat this stepuntil the device turns back ON.,2. To finish, press and hold STOP until the red light on the remoteturns off.Using Direct Entry1. Turn on the component to be programmed.f robVC_t Nd_ SAT-CAII_ItlVBt_ PrAYS/O#(D_v vYou'll use these buttons when youprogram the remote to control anydevice.The remote may not operate all modelsof all brands.22