REED R2320 Instruction Manual
                    | |
Contents
| 
12www.REEDINSTRUMENTS.comAdjusting EmissivityThe instrument's emissivity can be adjusted from 0.01 to 1.0 to meet thetype of surface being measured. Refer to the Emissivity Chart for refer-ence. Press the SET button three times to enter the emissivity setup. Pressthe button to toggle between emissivity preset values as indicated byP1-P5. Use the UP and DOWN buttons to set the emissivity values. Pressthe UP and DOWN buttons to add or subtract 0.01 unit and/or hold theUP and DOWN buttons to add or subtract 0.1. The instrument will exit thesetup after 10 seconds of inactivity or if the trigger is pulled at any time.Switching the Unit of Measure (°F/°C)Press the SET button four times to enter unit of measure setup. Use the UPand DOWN buttons to switch between °F and °C units. The instrument will exitthe setup after 10 seconds of inactivity or if the trigger is pulled at any time.continued...1.888.610.7664info@REED-Direct.com REED-Direct.com |
Related manuals for REED R2320
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine