Racelogic Ltd PerformanceTools Software02/05/2014 Page 42Selecting ChannelsAll channels logged by PerformanceBox appear in the data window; all except speed areinitially greyed out, but the data can still be seen. To enable a particular channel and make itvisible in the Graph window, click in the tick box to the left of the channel name. For example,to display lateral acceleration:PerformanceTools will automatically scale the channel to its minimum and maximum valuesand show it in the graph window. The enabled channel will then be highlighted in its displaycolour.The data table contains all of the logged channels from the PerformanceBox file plus Lateraland Longitudinal Acceleration and Radius of Turn channels, calculated when the file is firstloaded. Scroll up and down the channel list to find the desired channel.A channel can also be found by typing the first letter of the channel, for example ‘S’ forSatellites, providing that the data table is the currently active window. If there is more thanone channel that starts with the same letter then press the key again until the software stopson your desired channel.Show Selected Channels OnlyThe data table channel list can be reduced to show only the ticked channels, by right-clickingthe mouse pointer in any ‘graph’ window (Graph, Data, or Map) then selecting ‘ShowSelected Channels Only’. This is very useful when you are moving the cursor through thegraph window and wish to see the displayed channel’s data at the cursor point:Click here toturn the channelon or off