GL815E Endura Motherboard Product ManualPage 13 of 511.4.2 Front Panel ConnectionsThe primary controls and indicators for the motherboard are connected via the front panel connectorusing either a single ribbon cable to a 'front panel' assembly, or using a number of small PC-standard connectors. The functions are described below. See appendix B for the connector pin-outinformation.Power LEDThis can be used to connect either a single-color LED (usually green) or a two-terminal bi-color LED(usually green/yellow) to indicate the powered status of the motherboard. In both cases, the 'green'anode should be attached to pin 2 of the front panel connector. See the Indicators section later inthis document for further information.Power SwitchA momentary switch should be connected between pins 6 and 8 of the power connector if themotherboard is used with a soft-switch power supply. If the switch is closed for greater thanapproximately 4 seconds, the motherboard will power off immediately, regardless of the state of theoperating system, losing any system context information. This switch is redundant when using ahard-switch power supply.Reset SwitchIf used, a momentary switch connected between pins 5 and 7 will cause the motherboard to restartwhen closed.Hard Disk LEDA single color LED should be connected between pins 1 (anode) and 3 to indicate hard disk activityon either of the two ATA channels.SpeakerConnect an external speaker between pins 10 and 11 or 10 and 16. This is used only for the PC'beep' functions - it cannot be used as an output of the audio CODEC. The speaker should typicallybe 8Ω.Tamper SwitchConnect a momentary switch between pins 18 and 20 to make use of the tamper detection logic ofthe motherboard. The switch should be open when the chassis is closed.Infra-red portPins 9, 11, 13 and 15 provide an interface to an infra-red receiver/transmitter module. Pins 9 and 13provide the +5V module power and signal ground return.