Radionics D7212 Operation And Installation Manual
Also see for D7212: Installation and troubleshooting quick referenceOwner's manualOperation and installation manualInstallation and troubleshooting quick referenceInstallation and troubleshooting quick reference
                    | |
D7212 Operation & Installation ManualPage 13 © 1993-1996 Radionics74-06913-000-B 2/96InstallationBefore You BeginThisInstallation section contains a general installation procedure. It refers you to othersections of the manual for detailed instructions.Radionics recommends you review this manual and theD7212 Program Entry Guide(74-06915-000) before you begin the installation to determine the hardware and wiringrequirements for the features you want to use.Have the following additional documents handy as you read through this manual:•D7212 Program Record Training Sheet (74-06895-000)•Security System Owner’s Manual (71-06633-000)•D7212 Operation and Installation Manual (74-06144-000)Before you begin the installation of the D7212 you should be familiar with the operation ofthe D5200 programmer or the RAM II remote programmer.Enclosure OptionsMount the D7212 Control/Communicator assembly in any of the Radionics enclosureslisted below. Refer to theInstallation Guide for UL and Fire Applications in this manual todetermine if your application requires a specific enclosure.• D8103 Universal Enclosure (gray)• D8109 Fire Enclosure (red)• D8108A Attack Resistant Enclosure (gray)Beginning the InstallationMounting the EnclosureMount the enclosure in the desired location. Be certain to use all five mounting holes. SeeFigure 2.Figure 2: Mounting EnclosureHOOK OPENINGSLOCK-DOWN TABSKIRT MOUNTING HOLEMOUNTINGSKIRT HOOKMODULE MOUNTINGLOCATIONSMOUNTINGSKIRT HOOKTAMPER SWITCHMOUNTING LOCATIONMODULEMOUNTINGLOCATIONSBACK OF D7212POINT CHART LABEL |
Related manuals for Radionics D7212
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine