Radionics D7212 Operation And Installation Manual
Also see for D7212: Installation and troubleshooting quick referenceOwner's manualOperation and installation manualInstallation and troubleshooting quick referenceInstallation and troubleshooting quick reference
                    | |
D7212 Operation & Installation ManualPage 17 © 1993-1996 Radionics74-06913-000-B 2/96Make the Telephone ConnectionsSeeTelephone Connections. If you are connecting the D7212 to a ground start phonesystem, you need to install D136 relay, seeInstall Modules and Relays on the previouspage.Connect the On-Board Points and Command CentersConnect the on-board point and command center wiring to the D7212. See theOn-BoardPoints andArming Devices sections for instructions.Power UpReconnect the battery and then plug in the transformer. Remember the buzzer sounds for10 seconds when you first power up the panel.Leave the reset pin locked down for now.Yellow Charging Status LED doesn’t go out: If the yellow charging status LED doesn’tgo out within 5 minutes of powering up the panel, the battery may be deeply discharged, oryou may have connected too many powered devices to the panel. Combined continuouscurrent draw for terminals 3, 8, and 32, and the Accessory Connector (J2) cannot exceed1.4A. See thePower Outputs section for help.Programming the PanelIf you haven’t created a program for the panel, review theD7212 Program Entry Guide (74-06915-000). Check to be certain you have all the required accessory modules installed forthe features you want to use.Use the D5200 Programmer or the RAM II remote programmer to load your customprogram into the panel.Move the reset pin to the normal position. See Figure 3. The panel transmits reboot andbattery reports to the receiver.Install the Point Chart LabelPoint chart label required for fire systems with verification points: You must install thepoint chart label for fire or combined fire/burglary systems using verification points.Use the program record sheet to gather the information you need to fill out the point chart.Install the label on the enclosure door as shown in figure 2. To avoid smearing your entrieson the chart, use the label's peel off backing to press the label in place. |
Related manuals for Radionics D7212
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine