Rae MiniRAE 2000 PGM-7600 Operation And Maintenance Manual

Contents

Rae MiniRAE 2000 PGM-7600 Operation And Maintenance Manual Manual pdf 68 page image

PROGRAMMING4-304.7.5 Change User ModeThere are two different user modes: Display and Program thatcan be selected from the programming menu.1. “Change User Mode?” is the fifth sub-menu item in theMonitor Setup menu (Table 4.7).2. Press the [Y/+] key; the display shows the current usermode selected.3. Press the [Y/+] key to accept the currently displayed usermode. Press [N/-] key to toggle to the alternate user modes.Press [MODE] to exit this sub-menu and move to the nextmonitor setup sub-menu.4. If there is any change to the existing selection, the displayshows messages “Program change” and “Are you sure?”Press [Y/+] to confirm the change or press [N/-] or[MODE] to discard the changes and move to the next sub-menu.CAUTION: If the user mode is changed to Display mode, theuser can no longer enter the programming mode. Therefore, theuser can not change the user mode back to Program mode innormal mode.To restore the user mode back to Program mode, turn the unitoff and back on in Diagnostic Mode. Next enter Program modeby holding the [MODE] and [N/-] keys for three seconds. Enterthe password at the prompt (the default is 0000). Once programmode is entered, go to the “Change Monitor Setup” / “ChangeUser Mode” and change the mode back to Program.An alternative way to change Display mode back to Programmode is through the PC and the ProRAE-Suite software.