MultiRAE User’s Guide278.2 Enter Programming In Basic Mode1. To enter Programming Mode, press and hold [MODE] and [N/-] until you see the Password screen.2. Input the 4-digit password: Increase the number from 0 through 9 by pressing [Y/+]. Step from digit to digit using [N/-]. Press [MODE] when you are done.If you make a mistake, you can cycle through the digits by pressing [N/-] and then using [Y/+] to changethe number in each position.Note: The default password is 0000.Note: The password screen only appears when you enter the Programming Mode the first time afterturning the instrument on in Basic Mode. If you have input the correct password, you do not have to inputit again to enter Programming Mode until you turn the instrument off and on again.Once you enter Programming Mode, the Calibration menu is highlighted. Press [N/-] to step through theprogramming screens.To enter a menu and view or edit parameters in its submenus, press [Y/+].
