ESP-SMT Smart Modular Control System21H Once you’ve identified the correctsoil type for the site; press the downarrow button until the desired soiltype is blinking; press the SELECTbutton.Select Sprinkler Type MethodI The SPRINKLER TYPE screen willappear;Press the up or down arrow button(s)to navigate to the dominant sprinklertype for that zone; then press theSELECT button.! NOTE: It is recommended thatthe Default Net Application rate beadjusted to match the actual zoneconditions. See pages 81-83 fordifferent methods to determinethe correct value.J The screen will display the defaultNet Application Rate for thesprinkler type selected.K If you need to change this value tobetter match the actual applicationrate, press the - or + button(s) untilthe desired value is shown.L If choosing Drip as the sprinklertype, you will be given two types ofdrip to select from.a. When Drip is blinking on the display,press the SELECT button.b. Select Point Source or Inline Grid.JROTOR Zone 2Net Application Rate:NEXTBACK0.45 in/hrKROTOR Zone 2Net Application Rate:NEXTBACK0.25 in/hr8SOIL TYPESELECTBACKZone 2Sand Loamy SandSandy Loam LoamClay Loam Silty ClayClayHelp9SPRINKLER TYPE Zone 2Sprays RotorsBubblersRotary NozzleDrip- OR -Time-BasedSELECTBACKSprinkler Type - Default NetApplication RatesNet ApplicationSprinkler Type Rate (in/hr)SpraysRotorsBubblersPoint Source DripRotary Nozzle1.600.452.500.800.50LSPRINKLER TYPE Zone 2Sprays RotorsBubblersRotary NozzleDrip- OR -Time-BasedSELECTBACKa.LDRIP Zone 2Point SourceInline GridSELECTBACKb.
