Rangemaster 110 Electric User Manual

Also see for 110 Ceramic: User guide User's guide & installation instructions User guide User's guide & installation instructions

Rangemaster 110 Electric User Manual Manual pdf 23 page image

23Electrical ConnectionThis appliance must be installed by a qualifiedelectrician to comply with the relevant regulationsand also the local electricity supply companyrequirements.Make sure that the mains characteristics (voltage,nominal, power, etc.) match the ratings indicated onthe data plate affi xed to the lower right hand cookerupright (remove storage drawer). The cooker is presetfor a single-phase earthed electrical connection. Itis essential to install a multi-pole circuit breaker thatcompletely disconnects the appliance from the mains,with a minimum contact break distance of 3mm.WARNING: THIS APPLIANCE MUST BE EARTHEDThe appliance must be connected to an effi cientearthing circuit. If the electricity network is not equippedwith an earth connection, then it must be installedseparately in compliance with local regulations. Earthingis a safety measure required by law, and must beperformed with particular care by a qualifi ed technician,who must also check that the electricity supplycharacteristics are correct.The cable size used should be suitable for the applianceload and in accordance with local regulations. Pleasenote the maximum cable sizes are 6mm 2 for the screwterminals and 10mm2 for the 3 pronged links.Access to the mains terminal is gained by removing theelectrical terminal cover box on the back panel. Connectthe mains cable to the correct terminals for yourelectrical supply type (see fi g.).Check that the links are correctly fitted andthat the terminal screws are tight.Secure the mains cable using the cable clamp.This shows the single-phase connection.Current Operated Earth LeakageBreakersWhere the installation is protected by a 30 milliampsensitivity residual current device (RCD), the combineduse of your cooker and other domestic appliances mayoccasionally cause nuisance tripping. In these instancesthe cooker circuit may need to be protected by fi tting100mA device. This work should be carried out by aqualifi ed electrician.Fitting the plinthLoosen the 3 screws along the front bottom edge of thecooker. Hook the central keyhole over the central screw.Twist and fi t each end keyhole over their respectivescrews. Tighten the fi xing screws.Oven LightPress the oven light switch and check that the light isworking.NB The oven light bulb is not included in theguaranteeHobplateTurn on each plate in turn and check that it heats up.GrillOpen the grill compartment door. Turn on the grill controland check that the grill heats up.Oven checkThe clock must be set to the time of day before theovens will work.Press and hold as shown.At the same time, press - or + until the correct timeshows.Don’t forget it’s a 24 hour clock.If you make a mistake or press the wrong button, turnoff the power supply for a minute or two and start again.Turn on the oven and check that the oven fan startsto turn and that the oven starts to heat up. Turn off theoven.Customer carePlease complete your details in this Guide, inform theuser how to operate the cooker and hand over theInstructions.Thank you.