8The ClockYou can use the timer to turn the ovens on andoff. The clock must be set to the time of daybefore the ovens will work.To set the time of dayPress and hold as above. At the same time,press (-) or (+) until the correct time shows.Don’t forget it’s a 24 hour clock. If you make amistake or press the wrong button, turn off thepower supply for a minute or two and start again.To time something that’s cooking(minute minder)Press and hold theMinute Minder ( ).At the same timepress (-) or (+) untilthe time you want tocook for is shown.You can check time remaining by pressingand cancel the beeper by pressingTo stop automaticallyUse when you have started the oven manually.Press and hold theStop Time ( )buttton.At the same time press (-) or (+) until yourrequired ‘Stop Time’ shows. AUTO will show inthe display. When your cooking is fi nished thebeeper sounds. TURN THE OVEN KNOB TO0 FIRST, then press once to stop the beep,press again to return to manual cooking.To start and stop the ovenautomaticallyBefore you set the clock, you must have twonumbers clearly in mind.The ‘cook period’, which is the period of timeyou want the oven to cook.The ‘stop time’, which is the time of day youwant the oven to stop cooking.You cannot set a start time directly - this is setautomatically by setting the cooking period andstop time.Press and hold theCook Time ( )button. At the sametime press (-) or (+)until your required‘cook period’ shows.Press and hold theStop Time ( )buttton.At the same timepress (-) or (+) untilyour required ‘stoptime’ shows.AUTO will show in thedisplay.Set the oven to the required temperature. Whenyour cooking is fi nished the beeper sounds.TURN THE OVEN KNOB TO 0 FIRST, thenpress once to stop the beep, press again toreturn to manual cooking.If you are out, don’t worry about the beepergoing off, it stops after a while. When you return,TURN THE OVEN KNOB TO 0 FIRST, thenpress twice, to return to manual cooking.AUTO is showing, you want toreset to manual cooking.When cancelling an automatic setting, anycooking time already set must be returnedto 0.00 before you can return to manual, bypressing the button.