Rangemaster Classic 110 Gas User's Manual & Installation Instructions

Also see for CLASSIC 110 GAS FSD: Installation and user guide User's guide & installation instructions User guide

INSTALLATIONCheck the appliance is electrically safe and gas sound when you have finished.27Pressure TestingThe gas pressure can be measured at one of the hotplateburner injectors (not the wok burner).Lift off a burner head. Fit the pressure gauge to the injector.Turn on and light one of the other hotplate burners.Turn on the control knob for the burner with the pressuregauge fitted to let gas through.See the data badge for test pressures.Turn off the burners. Make sure that you reassemble theburner top in the correct way on the burner body.Electrical ConnectionThe cooker must be installed by a qualified electrician, inaccordance with all relevant British Standards/Codes ofPractice (in particular BS 7671), or with the relevant nationaland local regulations.nn WARNING: THIS APPLIANCE MUST BE EARTHED.All external wiring must comply with the IEE Regulationsfor the Electrical Equipment of Buildings. Connection to theelectrical supply can be made with either a plug and socketor be permanently wired via a double-pole switch. The cookeris supplied with a 3-core cable 2 m long. If a replacementcable is fitted it must be 250 V high temperature PVC (85 °C),1 mm².Should the plug not fit the socket in your home, it should beremoved and replaced with a suitable plug.Note: If the plug is fitted is not suitable, it must be cut off anddisposed of properly. To avoid the risk of electrocution, theplug must not be left where children might find it and plug itinto a supply socket.Three pin plugs to BS 1363 with a capacity of not less than13 A must be used and fitted with a 13 amp fuse ‘ASTA’approved to BS 1362.You MUST refit the cover after replacing the fuse. If the coveris lost, the plug MUST NOT be used until a replacement coverhas been obtained from your supplier. The colour of thecorrect fuse carrier is that of the coloured insert in the base ofthe fuse recess, or stated elsewhere on the plug. Always statethis colour when ordering a replacement fuse carrier.IMPORTANT: The wires in the mains lead are coloured inaccordance with the following code (Fig.7.12):Green and yellow: EARTHBlue: NEUTRALBrown: LIVEEarth: to theterminal marked E,coloured Green/YellowLive: to theterminal marked L,coloured BrownNeutral: to theterminal marked N,coloured BlueFig.7.12