Rangemaster Excel 110 Ceramic Users Manual & Installation

Also see for Excel 110 Ceramic: User guide User's guide & installation instructions User's guide & installation instructions User's guide & installation instructions

Rangemaster Excel 110 Ceramic Users Manual & Installation Manual pdf 26 page image

26Moving the CookerThe cooker is very heavy. Take great care.We recommend two people manoeuvre the cooker. Ensurethat the floor covering is firmly fixed, or removed to preventit being disturbed when moving the cooker around. You willneed the levelling tool.Pull the warmer drawer out to its furthest point.Lift it up and out.Fit the levelling tool on the rectangular adjuster as shownbelow.LOWER THE FRONT ROLLER by doing 14 complete (360°)turns clockwise. (This means turning and removing thelevelling tool 56 times).Now LOWER THE TWO REAR ROLLERS.First fit the levelling tool on the hexagonal adjusting nut asshown below.Make 10 complete (360°) turns clockwise. (This meansturning and removing the levelling tool 20 times).Make sure you lower BOTH REAR ROLLERS. There are twoadjusting nuts, one for each roller, at both the front bottomcorners of the cooker.Carefully push the cooker backwards close to its finalposition leaving just enough space to get behind it. Takecare not to damage the power cable.Do not use the door handles or control knobs to manoeuvrethe cooker. Remove the pack base tray.LevellingYou are recommended to use a spirit level on a shelf in oneof the ovens to check for level.Place the cooker in its intended position taking care not totwist it within the gap between the kitchen units as damagemay occur to the cooker or the units.The rollers can be adjusted to level the cooker. To adjustthe height of the rear of the cooker use the levelling toolsupplied to turn the adjusting nuts at the front bottomcorners of the cooker.Adjust the height of the front roller to level the cooker. Turnclockwise to raise the cooker and anticlockwise to lower.When you are satisfied with the height and level raise thefront of the cooker by one turn of the front roller adjuster.Screw down the front feet to meet the floor. Screw the frontroller adjuster anticlockwise to raise the front roller so thatthe front of the cooker is supported on the feet, not thefront roller, to prevent accidental movement of the cooker.Leave the levelling tool on the adjuster with the handleof the tool facing the rear of the cooker, so that thecustomer can use it if they wish to move the cooker.Replace the drawer by locating on side runners and push in.