INSTALLATIONCheck the appliance is electrically safe and gas sound when you have finished.21ArtNo.010-0004 Moving the cookerArtNo.105-0010 - 100 Fitting the stability bracketA70 mmC D500 mmBB600 mmArtNo.010-0010 Lowering the rear rollers (90)x10Fig.7-6Fig.7-7Fig.7-8A – Wall face, B – Rear rollers, C – Front levelling feet,D – Pencil datum lineFig.7-5Lowering the Two Rear RollersFirst fit a 13 mm spanner of socket on the hexagonaladjusting nut (Fig.7-5). Make 10 complete (360°) turnsclockwise (Fig.7-6).Make sure you lower BOTH REAR ROLLERS. There are twoadjusting nuts, one for each roller, at both the front bottomcorners of the cooker.Completing the MoveUnfold the rear edge of the pack base tray. Open the grilldoor and right-hand oven door so that you can get a goodgrip on the bottom of the fascia panel as you move the oven(Fig.7-7).Carefully push the cooker backwards off the pack base.Remove the pack base tray.Position the cooker close to its final position, leaving justenough space to get behind it.nn Do not use the door handles or control knobs tomanoeuvre the cooker.Fitting a Stability BracketA stability bracket or chain (not supplied by with the cooker)should be fitted when the cooker is connected to a flexiblegas supply.When fitting a stability bracket, read these instructionstogether with the leaflet supplied with the bracket.1. Place the cooker in its intended position and level thecooker.2. Draw a pencil line 70 mm from the front edge of thelevelling feet.3. Mark the centre line for the bracket by measuring600 mm from the left-hand side of the cooker.4. Move the cooker forward.5. Measure back from the pencil line 500 mm to locate thefront edge of the bracket (Fig.7-8).6. Position the bracket so that it is away from centreline ofthe cooker to reduce the possibility that it will trap theelectrical connection cable or gas hose.7. Fix the bracket to the floor.8. Measure the height from floor level to engagementedge in back of cooker. Add 3 mm to this dimension andassemble the stability bracket to this height (i.e. fromfloor level to underside of the top member), and ensurethe bracket does not foul the oven burner assembly.Repositioning the Cooker followingConnectionIf you need to move the cooker once it has been connectedthen you need to unplug it and, having gripped under thefascia panel and lifted the front of the cooker slightly(Fig.7-7), you need to check behind the cooker to ensure thatthe gas hose is not caught.