en-9RANSOMES HIGHWAY 2130SAFETY AND OPERATORS MANUALStandard ISO 2631-1: 1985 Evaluation of humanexposure to whole body vibration -- Part 1: Generalrequirements.4.3 VIBRATIONThe machine was tested for whole body and hand/arm vibration levels. The operator was seated in thenormal operating postion with both hands on thesteering mechanism. The engine was running andthe cutting device was rotating with the machinestationary.Standard ISO 5349: 1986 Mechanical vibration.Guidelines for the measurement and the assessmentof human exposure to hand-transmitted vibration4.6 CUTTING PERFORMANCE45 cuts per meter at 12 km/hr with 8 knife floatinghead units.62 cuts per meter at 12km/hr with 11 knife floatinghead units.23 cuts per meter at 12 km/hr with 4 knife fixedhead units.34 cuts per meter at 12 km/hr with 6 knife fixedhead units.4.7 CUTTING PERFORMANCE (AREA)2.3 Hectares/hour at 12 km/hr with float head units.2.3 Hectares/hour at 12 km/hr with fixed head units.A 10% allowance is included for normal overlapsand turning at the end of each cut.4.4 SLOPESDO NOT USE ON SLOPES GREATER THAN 15°The slope 15° was calculated using static stabilitymeasurements according to the requirements ofEN 836.4.5 RECOMMENDED LUBRICANTSEngine oil: Should be to MIL-L-2104C or toA.P.I. Classification SE/SF/SGgrades. [10W-30]Hydraulic Oil: ISO VG46, or equivilantGrease: K NATE (RJL No. 4213860), orequivalent to MIL-G-23549C,MIL-G-2345C, DIN 51 825,DIN 51 818.ERUTAREPMET YTISOCSIVLIO)F°93(C°4EVOBA 03EAS)F°93(C°4WOLEB 03-W01ro03-W5EAS4 SPECIFICATIONS0312yawhgiHKD/SC/UC/JWseireSnoitareleccAmrA/dnaHlevelHRroHLxaMs/msnoitareleccA 2qeAX qeAY qeAZ313,0 953,0 422,0eulaVtnanimoD 953,00312yawhgiHUC/JWseireSKD/SC/ydoBelohWnoitareleccAlevelnoitacoLroolFs/msnoitareleccA 2noitacoLtaeSs/msnoitareleccA 2x y z x y znaeM 8420,0 9510,0 2570,0 010,0< 0910,0 3310,0