CHAPTER 9: DEVICE MANAGEMENT 99SNMP Trap ConfigurationSNMP provides the ability to send traps, or notifications, to advise an administrator when one ormore conditions have been met. The following table lists the Dominion KX II SNMP traps:TRAP N AME D ESCRIPTIONcimConnected A CIM is plugged into to the Dominion KX II port.cimDisconnected A CIM is either unplugged from the Dominion KX II port or powered-off.cimUpdateCompleted CIM firmware update process completed.cimUpdateStarted CIM firmware update process started.configBackup The device configuration has been backed up.configRestore The device configuration has been restored.deviceUpdateFailed Device update has failed.deviceUpgradeCompleted The Dominion KX II has completed update via an RFP file.deviceUpgradeStarted The Dominion KX II has begun update via an RFP file.ethernetFailover An Ethernet failover was detected and restored on a new Ethernet interface.factoryReset The device has been reset to factory defaults.firmwareFileDiscarded Firmware file was discarded.firmwareUpdateFailed Firmware update failed.firmwareValidationFailed Firmware validation failed.groupAdded A group has been added to the KX II system.groupDeleted A group has been deleted from the system.groupModified A group has been modified.ipConflictDetected An IP Address conflict was detected.ipConflictResolved An IP Address conflict was resolved.networkFailure An Ethernet interface of the product can no longer communicate over thenetwork.networkParameterChanged A change has been made to the network parameters.passwordSettingsChanged Strong password settings have changed.portConnect A previously authenticated user has begun a KVM session.portConnectionDenied A connection to the target port was denied.portDisconnect A user engaging in a KVM session closes the session properly.portStatusChange The port has become unavailable.powerNotification The power outlet status notification: 1=Active, 0=Inactive.powerOutletNotification Power strip device outlet status notification.rebootCompleted The KX has completed its reboot.rebootStarted The KX has begun to reboot, either through cycling power to the system or by awarm reboot from the OS.securityViolation Security violation.startCCManagement The device has been put under CommandCenter Management.stopCCManagement The device has been removed from CommandCenter Management.userAdded A user has been added to the system.userAuthenticationFailure A user attempted to log in without a correct username and/or password.userConnectionLost A user with an active session has experienced an abnormal session termination.userDeleted A user account has been deleted.userLogin A user has successfully logged into the KX II and has been authenticated.userLogout A user has successfully logged out of the KX II properly.userModified A user account has been modified.userPasswordChanged This event is triggered if the password of any user of the device is modified.userSessionTimeout A user with an active session has experienced a session termination due totimeout.vmImageConnected User attempted to mount either a device or image on the target using VirtualMedia. For every attempt on device/image mapping (mounting) this event isgenerated.vmImageDisconnected User attempted to unmount a device or image on the target using Virtual Media.
