Appendix C: Specifications129Port DescriptionKVM-over-IP)Protocol,Configurable Port5000communication between Raritan devices and systems, includingCC-SG for devices that CC-SG management is available.By default, this is set to Port 5000, but you may configure it to use anyTCP port not currently in use. For details on how to configure thissetting, see Network Settings.SNTP (Time Server)on ConfigurableUDP Port 123The KX III offers the optional capability to synchronize its internal clockto a central time server.This function requires the use of UDP Port 123 (the standard forSNTP), but can also be configured to use any port of your designation.OptionalLDAP/LDAPS onConfigurable Ports389 or 636If the KX III is configured to remotely authenticate user logins via theLDAP/LDAPS protocol, ports 389 or 636 will be used, but the systemcan also be configured to use any port of your designation. OptionalRADIUS onConfigurable Port1812If the KX III is configured to remotely authenticate user logins via theRADIUS protocol, either port 1812 will be used, but the system can alsobe configured to use any port of your designation. OptionalRADIUS Accountingon Configurable Port1813If the KX III is configured to remotely authenticate user logins via theRADIUS protocol, and also employs RADIUS accounting for eventlogging, port 1813 or an additional port of your designation will be usedto transfer log notifications.SYSLOG onConfigurable UDPPort 514If the KX III is configured to send messages to a Syslog server, then theindicated port(s) will be used for communication - uses UDP Port 514.SNMP Default UDPPortsPort 161 is used for inbound/outbound read/write SNMP access andport 162 is used for outbound traffic for SNMP traps. OptionalTCP Port 22 Port 22 is used for the KX III command line interface (when you areworking with Raritan Technical Support).SSH (Secure Shell) SSH port can be configured. The default is port 22.Telnet Telnet port can be configured but is not recommended. The default portis 23.HTTP and HTTPS Port SettingsYou are able to configure HTTP and/or HTTPS ports used by the KX III.For example, if you are using the default HTTP port 80 for anotherpurpose, changing the port will ensure the device does not attempt touse it.To change the HTTP and/or HTTPS port settings:1. Choose Device Settings > Device Services. The Device ServiceSettings page opens.
